chuahcs =D
One question, you are using Umobile firmware/Tre firmware for your MF680?
I tried both firmware with my Openwrt MR3420 but I notice the signal strength have no different.
Speed wise, Tre firmware seem a bit faster then Umobile firmware. (still under observation)

This post has been edited by Ruzumaki: Nov 14 2012, 06:00 PM

i am using the swedish firmware. Umobile firmware is a lot slower. Yours is tre firmware how it perform in speed?

---

Added on November 14, 2012, 6:27 pmThis post has been edited by chuahcs79: Nov 14 2012, 06:27 PM

Huawei E398

The only modem ensured to be compatible with Malaysia LTE :hehe

Swedish firmware is which one??
Im using this one http://www.tre.se/Privat/Kundservice/Kom-i...band/ZTE-MF680/

just receive my MF680...
after run speed test...the speed seem disapointed =.=
my ipad3 can easy get over 10mbps but this modem only get 3mbps =.=
i not sure is it my ipad3 receiver more strong than my 3g modem =.=

by the way, any1 experience slow connection when using with TP link 3g router? ....i use TL3420 and TD8968..both give me around 1mbps only...not sure what the reason -.- ...
any1 have this issue?

TD8968 V2 ?

how much you bought it?

When i used MR3420, my speed is faster than direct raw plug in

yea that's the one, stated in websites B05 but is B04,.. the source link from linkeong

---

Added on November 14, 2012, 8:56 pmmy direct plug in speed is finally same like plug in mr3420 now after performs surgery on handicap maxis set E372 added some heatsink + panel antenna

This post has been edited by chuahcs79: Nov 14 2012, 08:56 PM

mine is TD8968...both V1 and V2 different is firmware..
once u upgrade the firmware, then is consider V2...
now my speed is ipad3>direct plug > router

---

Added on November 14, 2012, 9:26 pmbut problem is MF680 modem why so hot
just 1 hour using already so hot -.-

---

Added on November 14, 2012, 9:30 pmdirect connect speed so nice now ...as good as my ipad3 speed



This post has been edited by stevenlee: Nov 14 2012, 09:30 PM

there's a few tricks ,

E372 also similar heat if u open the cover too

just leave the sim card cover open,.. use some fan to blow the air either to the side external antenna hole, or the other side Micro SD card slot,. it will help to cool the ZTE MF680 down,..

ZTE MF680 cover material is thinner then E372,. that's why u easily feel it hotter,.

there is no way to open the ZTE MF680 front cover because once it open up, the second silver antenna will dettach and signal /speed both will go down tremedously,

no matter how i try to pin the silver thing back on the board without cover, it will wont work,.. so only can use with front cover close

This post has been edited by chuahcs79: Nov 14 2012, 09:33 PM

will the cover melt after long hour using
chuahcs, where u stay? maybe can drop by ur house for modem testing

haha, just found out i finally break the 1MByte/s barrier on my sim d

This post has been edited by noobandroid: Nov 14 2012, 10:06 PM

i stay farlim,. yeah of course you are welcome

nah, the cover wont melt la, not so serious, just that compare with E372 cover, zte cover easily feel hot than E372,.

but when both modem open cover, the inside temperature is exactly the same HOT,.


miss this speed, finally it is back

I wonder my so-called unlimited maxis broadband speed was crapped down due to over usage of quota

well last 3 days i am facing some tower issue in my area,

until now my speed is back on track,.

so may be is your tower issue, as maxis capped speed = 128Kbps only

thats not a capped speed, if want a capped speed, its 256kbps

though maxis capped speed is standard 128Kbps ?

maxis change new policy ka ? 256Kbps ?

Do I need to lodge a complaint again to Maxis?

from maxis new BB plan T&C:

* Upon finishing your allocated monthly quota, the speed for the 3GB and 8 GB plans will be throttled to 64 kbps. The other plans will be throttled to 128 kbps. Fair usage policy applies.

ops, i think i upgraded the speed ald, paiseh paiseh

can, but if capped to 128kbps, not my fault if you know what i mean

it might be your area tower issue,..

as i face this issue for last 3 days,. and then today is fine