QUOTE(Acid_RuleZz @ Nov 16 2011, 11:36 PM)
In HKEY_LOCAL_MACHINE\SOFTWARE\Microsoft\Dfrg\BootOptimizeFunction,
1. Create a new String name "Enable" and set value as 'Y'
2. LcnStartLocation and LcnEndLocation set the value as "0"
3. Set OptimizeComplete value as "No"
Then go to HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\services\SysMain,
1. Check if Start value is "2"
Done all these, try to do the command again..
I had done the BootOptimizeFunction, and just want to double confirm with you the SysMain start value. Is this value 2? I did not edit anything in SysMain yet. 1. Create a new String name "Enable" and set value as 'Y'
2. LcnStartLocation and LcnEndLocation set the value as "0"
3. Set OptimizeComplete value as "No"
Then go to HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\services\SysMain,
1. Check if Start value is "2"
Done all these, try to do the command again..
I had tried to run the cmd, but get the same error again. How now sifu?
This post has been edited by j-insigh: Nov 17 2011, 07:42 AM
Attached thumbnail(s)
Nov 17 2011, 07:14 AM
Quote
0.0316sec
0.56
6 queries
GZIP Disabled