meeeeee iiiimmmmmm brrroooookkkkeeeeeeeeeeeee

huwaaaaaa nanges gaji lg 2 minggu

kita serupa.... kita serupaaaaaaaa

x serupa...kete kita laju tapi xde saman pon lalalalala

Fuh, tangkap dlm punye

ehehehe jgn mare ye...samat ari raye maap zahir batin

ah..saja saja nak share dengan korang yang tak tau. Yang dah tau, tolong comment kasi idea sikit.

Project sumbat IAFM kedalam kereta ku.
Manifold besi sudah diremoved. Found out some difference that need to be fixed.

MAF sensor(not sure the correct term) has a different socket. Need to modify. (Possible to use back the old sensor, but need to modify abit which i would like to remain original.Incase project failed, can use back)

The sensor at the throttle body that connects to the petrol charcoal canister. At a glance, it can use back the original 1. Else the socket has to be modified too.

Throttle body is not the same as iafm. But it has the same base. So just remove the pin at the iafm manifold and good to go.

Wire harness. Ini kepala sakit. The original wire loom is routed above the manifold. But IAFM manifold has no hole in between to route part of the wiring harness. So have to find a way to route it below manifold, or above.

At the moment ini macam saja. Wait when i futher work, i will update ye...

wah byknya kerja nak kena buat.. ingatkan pnp je

aku memang pun ingat senang...mana tau bukak bukak..banyaknya barang kena buat.
tang IAFM flap tu pun dalam theory phase lagi. Wait i success baru i posting itu.

sementara manifold tu dah keluar, buat valve cover gasket leaking sekali..

if i'm not mistaken i did tell in gen2 thread that dori2 at subang can install that IAFM for rm100...

aku gi subang = money gak.
buat leaking = money gak.
DIY = save money + knowledge free ~~
buahaha

aku dah miskin for the upcoming months

laju ker kalau sumbat masuk IAFM???

oi dont say like dat la.. not good

u can say: dana sudah kurang

eh bro, once a month u come down to KL from ipoh, make a business out of it la.. maybe u could buy something and sell it to your fren. charge them transport cost oni

project IAFM gagal.
Sebab sebab gagal:

1: Module IAFM akan tersangkut di alternator.
2: Cilinder satu akan sangkut pada hose air yang keluar dari block engine.
3: Belakang manifold akan sangkut pada hose hose steering rack.

atas sebab sebab yang ini, aku sudah official cancel project.

S@ni, takde benda yang ada di ipoh orang KL minat...takkanlah nak jual ahmoi ipoh pulak..

ada...pau yik moon...

Heard from one of my friends, if you drive above 180km/h then most probably speed traps cant catch you

police arent stupid and those speed trap device arent cheap

but why last time 184km/h they still can catch meeeeeee

even u drove bugati, speed trap will surely catch u...

unless use the special ehem ehem effect number 'plate'

i mau pinjam Conroe punya plate number la