I see. will ask mech to check for it.... btw, I remove the water slowly using AMW cup and a piece of cloth
Very hard to remove the steel cap

Guys the Saga club is having TT in Puchong this Sat, any Wajarians wanna join? They are asking Persona guys as well.

yeah MY fren     

---

Added on November 21, 2011, 8:46 am

ur oil will become black after run in the engine for more than an hour.... not to be racist but it does really become very black unless u use NGV.

Nope if with NGV it wont be dark im very sure... NGV release no HYDROCARBON.

Hmmmmm i wonder whats happening



Now this is what i call bling!

Heya guys, wanna ask, I have a Waja 4G18P year 2002, original meter panel red colour. If change the meter panel bulb to white colour, will the whole meter panel become white or remain red?

nothing wrong with ur engine..... coz u start with petrol not NGV and run NGV after warm up... so u have intro hydrocarbon to the engine.... so later on it become black lor

Yeah.. thats why now want to play with siput.

Greetings everyone. Emm can anyone brief me on how to replace waja fog light bulbs? Hoho thankss

Okay thanks bro! :-) emm 6000k bulb? Price range and where can i easily get it yeah? Sorry still new with cars meh. anyways i need to jack up the front part is it?

it should not change much.... if his ori is 15" 195/50 upgraded to 17" 215/45 the speedo should be +5km/h only

FYI 195/50 on waja the speedo shows -10km/h

for waja with 17" 215/45 should be as accurate as GPS.... trust me coz im using military MTK 15hz real time GPS logger for my carpc.

stock cars always have "+" speed as a standard safety feature on commercial vehicle.

sorry... just now all the comments are terbalik hahahaha

stock cars tends to be faster on speedo by 5kmh to 10km/h

That means when the car is stationary it is actually moving 10 kmh wahahahaha

EDIT: Oops I think terbalik. should be when the speedo showing 10kmh you car is actually stationary   

Lights measured by lumens not K... K is kelvin where it is light temp colour. The best visibility of lights tru naked eyes is 4800k

The GPS you can buy from ebay aviation GPS module, it runs on TTL data where you need to design a circuit board to translate the TTL NMEA data to 232 Data via FTDI drivers. not all GPS support 15Hz because and comport RS232 had its maximum duty cycle too where you need to select properly all the config else it wont works. Aviation GPS is very powerful even indoor it will try to use others signals to triangulate.

i have another one where i posted in Waja V11
Something to share with u guys.... a bit off topic here hahahaha

Okay.... i just found that we can reprogram GM-2 GPS become military spec.... accuracy from 12" to 2.5 meter..

1st get a iBlue GM-2 (not china GM-2)

Download GPSview 1.2.1 to program your GPS to 5hz

Note Garmin do not work on this unit if the baudrate is higher than 38600. The higher frequency the smoother it goes...

Connect the GM-2 and install the driver....

Fire up the GPSview
» Click to show Spoiler - click again to hide... «
Follow the settings above

All is in $GP

GLL - Lat/Lon data
ZDA - Date and Time
GGA - Satellite Fix information
MCHN is a MTK NMEA sentence which shows the internal status of gps channels
GSA - Overall Satellite data
RMC - recommended minimum data for gps
VTG - Vector track an Speed over the Ground

The setting 1-5 is the frequency of data in sec. some set 5 some set 1 this is because i dont want to overload the data to RS232. Now the duty cycle should be 82%... dont try to push it to 100% else u will have a 232 crash and you have to recover the GPS using others software to init back the bootloader.

After setting.... click on the DGPS apply.. you will get WAAS Enabled....
WAAS is a GPS assistant which provide more accurate signal even indoor.

Follow all the settings above and click apply.

After u program it correctly, u should able to receive GPS indoor. (depends)

» Click to show Spoiler - click again to hide... «

---

Added on November 23, 2011, 12:47 amsee here http://forum.lowyat.net/topic/1737249/+1440

guys can anyone help me here? just now i send my car to change fog light bulb. that fella did it like so hard work. tested the bulbs on my waja punya fuse box to see if the bulb light or not. at last it worked la, use many many electric tapes (the black tapes) behind the fog light.. then i moved the car as usual.. everything is okay.. i parked my car and turned off the engine.. after i want to enter the car again, my car alarm suddenly don't work..use the keys to open, but no alarm sound.. i locked and unlocked my car from inside several times using door lock. then i try use alarm lock and unlock from inside the car.. things worked again. then suddenly idk what happened, my car everything reset..the radio, time all back to factory.. i start the engine, RPM is very low, then car mati.. everytime i slowdown or stop.. tunggu kejap my car mati.. now my signal on the affected fog light gone! no light. indicator also go very fast.. i called mr raja, one of the mechanic people advert in lowyat forum, he told me idle control in computer box reset, press the accelerator till 1.5 at speedometer for 5 mins.. turn off engine, then on again. i tried already.. so far so good but RPM still quite low.. tepat2 around 500 only.. what caused the problem and how to fix?

Lolssss... over feed data...

_________________________

Bro, try to clean the battery terminal.... remove the battery terminal and clean it with foil soaked with warm coke....

No need to change also can.... take the terminal out and sand paper clean it from inside. After that soak it in HOT coke for a moment. When you install back the terminal, remember to put some battery grease or lithium grease. To avoid future corrosion, cut a round shape like a donut sponge and insert into the batt terminal then sapu some grease on the sponge so that it will soak and store some grease to prevent the corrosion.

Yes it's coca cola.

Grease is to layer the protection to prevent It from exposing to air and corrode again

Just use back protons ATF. Around 120 ringgit. But don't pour coke inside.

Thought Captain Slow..... is that my new nick

---

Added on November 25, 2011, 11:07 am

Long long story.... better not to mention

---

Added on November 25, 2011, 11:08 am
finally upgraded right    

---

Added on November 25, 2011, 11:10 am

yup it will explode... careful its like putting the double signal for too long will melt the car and explode

ah 

---

Added on November 25, 2011, 11:30 am

Put big big "Cap'n Slow" sticker on your ride when it's done, then go troll Inspiras   

good idea..... but just to let u know i really spray my car PINK colour HAHAHAHAHAHA...... Pink Candy metallic

Paultan.org article
Jointly developed by Proton and Petronas kononnya, so should be available at Petronas petrol stations.
Dowan la...pictures la come 

Guys wanna confirm again if I can use ATF for power steering? Wanna make sure coz I've never top up my PS fluid before.

I use the old blue one..

anyone done this?

most of them cannot explain and the product is actually teflon coating....Teflon process, the high temperature - it's not a matter of "can't be easily achieved," it is impossible.

Teflon liquid protection normally would last 60 days to 6 month if no UV interference ...

most of the products claim its own chemical instead of teflon.... Dupont stop this products after being issue law suits

---

Added on November 27, 2011, 12:54 am3M - uses a 3 step technique wherein a mild abrasive is used to clean and polish the surface, then a synthetic resin is used to perapre the surface and lastly the glaze is used to shine the surface. IMHO and as per the information given to me by Paint specialists, results in cutting of the clear coat by about 5-7 microns. factory finished clear coat surfaces are normally about 40-50 microns and the mild fine liquid rubbing compound cuts off a bit of this clear coat which IMHO isnt very desirable. secondly helpless against Bird droppings. had done 3M coating on my sx4 and a bird dropping resulted in a cracked up kind of surface on the clear coat. this is a Good to have product

Waxoyl - Again a 3 Step application albeit a Much better technique wherein a synthetic resin is applied to the paint to prepare the surface, a gloss resin is applied to shine the surface and finally a 100 Plus polymer paint sealant is applied to seal the surface. by experience i have observed that the shine lasts upto 2-3 years and provides effective protection against bird droppings which are corrosive in Nature and leave a cracked looking surface on the paint. However the bird droppings need to be washed off the surface within 6-8 Hours for good results. water keeps beading on the surface even after 24 months of application and in my Humble opinion this is a must have product

Dupont teflon - a Single step system wherein the vehicle is cleaned and then the teflon applied to the surface, let to dry to a haze and then shined with an orbital Polisher. very difficult to get genuine Dupont teflon and most of the time dealerships and detailers use either 3M liquid wax or any other automotive wax and say its teflon  Genuine Dupont teflon comes in small bottles of 50-100 Ml each for a specific application and costs about 1045/- or so. if someone tells you that he will do a teflon coating demand to see the packaging of the product. in fact a few years ago when my friend did teflon coating for his scorpio, little did he know that the dealer would spray an additional coat of clear coat on his car and call it teflon!

Jewel Ultra Diamond Brite - Techinical specifications of this product look impressive and on par with waxoyl. the only hitch is that it is available only in Chennai as of now!

source BHP team

You bought from dealer ma right?
Yep. No surprises on the 15k figure....but the perodua fella quote make me wanna tell him that his myvi se extreme (that was on display on the hypermarket floor yesterday) is an overpriced piece of shit. 

Is it better to skim the brake discs first, or straight change new set..

Change new set must go together with new brake pads?

Sorry noob in cars, got my first car from brother.

Those are extreme ones.. one of the examples that we can see anywhere is carbon fibre hood..

Anyone here change their Auto Transmission fluid before? Just changed it today but my foreman said only require 5 litre. I saw manual need around 7.7 litre to change. ><