Jalan Gasing also got Ipoh Chicken Rice. Why Pudu shop cannot be at Jalan Gasing? 

i maintain in at 4.5k rpm to let it run at 180kmh wor...cz i wan to c at 180kmh wads d rpm...
tmr i try again...

If its the E-01 engine then im going to steal ckdenions car ady.. XD

Ckdenion, please take care of your legendary car. We going to tow it. 

Gasing became gelang? Where is this shop exactly?

Oic.. haha.. It was quite a close guess though.. haha.. What is the shop name again?
Yeah if only Proton were to come out with the Citroen DS3 design with E-01 engine.. It will be the most legendary model ever built..

wat model is it?
how many L this car??950euro!!

Actually from everything I've read and discussed with ppl with these technical backgrounds (I still newbie...),

Conclusion : Never never do engine flush UNLESS you're encountering engine issues that requires it (meaning last resort, no choice).

In lots of cases especially those that have lots of contaminants and sludge, doing flush might makes things worse. Flush will lossen those solid sludge. Where do some of these sludge go since its heavy and doesn't float? When you flush it, it will go thru oil passage, pumps, tubes, drain holes and chances are high these heavy solid will just stuck there.

If you're lucky and don't have much sludge to begin with, you might just make it. As do some of those that have already done flushes.

If any of these sludge do happen to get stuck in just any one of the above places, you're engine will kaput. When that happens, you will have to do a major overhaul....assuming it did not damage your engine enuf, if that happen, new campro CPS coming. Chinese proverb, mou si wan si lei chou meaning creating problem when there is none in the first place.

Another theory include using flush oil. Flush oil are very powerful solvent meant to loosen those sludge. There always will be a couple of % leftover in engine after finish flushing (not 100% will come out). Imagine those mixing with your engine oil and what it will do to your engine long term...go figure.

Excerpt for NBC Los Angeles says it all.

""After engine flushes, there's a pretty high incidence of some damage to the interior of the engine," Chris Martin of Honda tells NBC Los Angeles.

That's why Honda issued a memo to mechanics advising them not to perform engine flushes. Other major car-makers, including Ford, General Motors, and Nissan have all issued similar advisories against the service.

Why? Over time, gummy deposits can build up inside your engine. The chemicals used for engine flush, are supposed to break up those deposits. But car-makers say, pieces of that broken up sediment can clog up other parts of the engine and ruin it."
"

eh but nowdays some accessory shop doing oil change service, or the other way workshop selling accessory....especislly at small twon areas.

wei....Brothers at Kelana Jaya can change absorber, break pad and disc, install CAI, they have planty of jack and stand infront of the shop i belive they can change engine oil because they also selling engine oil......

Hi ..

New Persona B-Line Broze Garnet (A) reporting in . 

Just got my car last Saturday.

If u drive alone and turn off the radio, i can hear cit cit sound at the back and trr trr sound at the bottom left front windscreen ( at the tip of our wiper )

Also, (1.) at the 1.6 word at the back already missing
- already ask the SA to give me the (1.) word and will DIY
- btw, isit possible to DIY ? i dont hv time to go SC bcos of work.
So, now I want to seek advice which tinted is good ?

I'm prefer black and can reject most of heat during hot days.

Also to protect the dashboard from UV as well..

Xan the cit cit.......tikus is free give that come wit PE lah.....

u rolling down hill and free gear
1 family from god grandfather until god grandson...

7 + months old Bronze Garnet MLine A/T reporting in!

Thanks Xan..

Will take note about the sound friction at rubber once I get back from work.

As for now I noticed that the rubber fitting at the pillar between 2 side windows( between large & small wan there got 1 separator line ) is not fixed in its place..might be one of the reason of cit cit sound. haiz

As for the front side trr trr sound how do u solve the loose bracket on the A-pillar plastic cover temporarily ?

Thanks bro       

Sad case , due to my *need to be perfect midset* , the front pillar cover panel has been solve but it cost me a clip (white color) which I pull in and out solving the rattling sound . The clip almost destroy by me , in the end I need to use double side tape to hold back the panel. Hope the panel won't fall off suddenly. So pls be gentle , the plastic is so      if any one got sound on the front pillar tape up all the clip and ur done

dunno which pillar u all mentioning??

U know how much is that white clip ?

how to check the noise ws came from by friction or not?my one passenger side oso got tat kind sound when uneven road..onli morning and nite will appear..afternoon is ok lo..haiz

my front passenger door dun have..my rear right side door got the sound when press..after apply the leather cream oso got lo..i think i oso wanna take out the A pillar cover to tape the clip..

I assume the Dowontech is the alarm system u posted a video of here last time..
Quality looks nice, start stop button looks expensive.. Wuwu.. If it was cheaper then I would have invested in it..
Me too.. Next mod is to change the back brake drum to disc brakes.

Checked with other "authorized" SC on wheel alignment / steering senget problem, they can check for me but with charges ... 

So, I informed my SA abt it, n submitted the wheel alignment's reports to him, so that he will make a report to the service manager ... hope it will be resolve asap, at least let me install the chamber kit with my own pocket money without threatening me abt the warranty.

wow need to paid extra RM380 for us....

Bro, for question 3, you know the cover for the sport light, unlock button just above the HU, got plastic sound like you push got plastic sound. Any idea how to solve?

And problem 5, how do you tape the latch? I tape the hock kao kao also got sound. (hmm)

hahaha ... that's the 1st thing 1 did, 2 tyre shops somemore with the reports, 1 of the tyre shop recommended by them somemore ... 

That's why they said the tyre shops want to cheat me only by selling me the chamber kit.

I paid extra RM380 too -.-
Proton alarm is not that bad bro...

They need extra higher power transponder bypass kit to "tarik" the RF signal because Proton is using those ultra low frequency RF in their transponder.

For Toyota / Honda, you don't have to place the immobilizer chip near the receiver in order to crank your engine. But in Proton, the chip must be very near to the receiver only to deactivated the immobilizer.

It's not a bad thing afterall.