uma ceramic not biggest good block , there is another brand from thailand also got ceramic same price wit uma but bigger size of 63.5mm

@budakmentah

u take my block, i immediate tukar to this block..

u confirm, we go sek 13, there better no ppl...sure can get done in 1 day for both bike...

there pomen is senior, the sek 7 all newbies....

when rdy u tell me la, i now also kering d due stupid insurance company overcharge me, just repair car clutch pump, need buy car insurance and road tax.....

on the road stable at 55 to 75, highest previously at top 81.8....

u worry add a switch to on the fan when u think is hot...

i got switch but never on, cos always never over 70...

no need worry, mine is diasil 57, i x think is hot....

ur 54 shud x de rasa 1 la....

bro, need my caliper measure thickness? no need guess d....

the shoe if finish normally left about 3 mmm, the ceramic part. If thickness lower than tat or finish will sound at hub. Metal rubbing and kenot tight screw anymore......

3mm is guideline but ppl go lower than tat la, normally until kenot tighten and feel low oni change....

but for once kenot tighten need schedule to change already, when brake too low, kenot brake on time...

For tire thread, tire shop in US have the right to change your tire thread if below 3mm bcos safety.

They did research tats the safety margin....

Now my rear tire thread some have 1.57 mm thread and some 2.59mm thread, i ask a lot ppl say need to change in maybe 1k more....anyway i just becareful since i m using tube...

2nd call, 1 eat free pizza now, i can wait for you....

since no response, i go liao,....

This post has been edited by NewGUY: Jul 24 2011, 02:38 PM

thianz FZ cam

me high cam but x the super high cam (just found out CMS profile lebih kurang ride-it profile lebih kurang Yamaha S6 profile ) for LC cam

no prob here,
1) EO leak x enuf due to your leak (gas rosak/keras) or low will have sound...(check EO level, repair leak 1st)
2) pomen put the teppet gap too tight, mine set in 10, out 15 (if pomen x 1 set)
3) EO i still using 20w/50 so sure no sound (use this EO will reduce the sound)
4) the above kenot settle look for pomen will to do...

yamalube +/- 1200km not more than 1400km (feel your engine) this is almost what every say...
car mineral EO +/- 1600km not more than 2000km (feel your engine) this i tested d
semi between +/- 2500 (feel your engine) this refer other version guideline
fully between +/- 3500 (feel your engine) this refer other version guideline

This post has been edited by NewGUY: Jul 25 2011, 10:35 AM

Oversea International Mat Rempit

oversea SBK Mat Rempit....

This one only call power, police also kenot do anything.....

This post has been edited by NewGUY: Jul 25 2011, 11:48 AM

wide rim and big tire is stable but you ll lose some top...

this some info i got

1.85 max recommended 100/80

2.15 recommended for 110/70

Stock LC ES 2011 is 2.5 use 100/70 (pomen say track tire size)

Since now got this size, then I ll try later bcos sure lighter than 100/80 and lower.....

@budakmentah,

i m selling my FZ block not more than 200, PM me if you 1....

change bigger block la, just dun 1 many motor parts laying around my house before i change anything and to prove is still working....

My hand use about 7500+ km for this block, when i bought this bike the meter already bout 33K, so i guess he change after 10K like that after the warranty....

wat think can work? pls reply the correct post, tq......

depends maybe 63.5mm or decide later or after actually got people comment on the block 1st. Nobody 1 my block yet anyway....

face can still be seen in certain angle without reflection and with good light source.I think he found the angle....

y u ppl kenot see face? just askin hope x mind, u planning to samun or rob bank is it?

now 1 to raya, let those police got another excuse to summon you....

BTW, u wear at night make ensure u have enough light source or not, you will hit something or go in semak...

Last time when at night, I use dark visor, I corner and kenot see it is uphill and got grass (actually need bigger turning but I just makan dalam, so sangkut corner grass there....

When I wake up morning at home, I see my foot rest got 1 huge gumpal grass, my housemate said you go cabut rumput with bike ar......

This post has been edited by NewGUY: Jul 26 2011, 09:45 AM

u go subang might as go shah alam sek 13, opposite Carlsberg and gardenia at federal highway, the shop is behind esso. Actually is beside tesco extra shah alam....

that is control by pressure of radiator cap which indicate the valve to open at 0.9 psi which correctly describe by thianz depends on temperature..

temperature heat up the radiator until the pressure of 0.9 psi, the valve will open...

temperature is directly proportional to pressure...

This post has been edited by NewGUY: Jul 26 2011, 09:57 AM

please refer below for map and add

Storm Bikers or Wee Bikers

For Sek 13, u call them up because is a new shop...

The add above is Sek 7...sorry...

This post has been edited by NewGUY: Jul 26 2011, 09:59 AM

Bro, is it ok to change the cap to higher pressure like maybe 1.1 psi? Someone explain to me, this will delay valve to open? whats the use then since we want it open earlier? 1.1 psi is the only cap available right?