Need help here, 
I got a set of new Wira 1.5 ventilated disc rotor and I wish to convert my 1.3 solid disc rotor to ventilated. What are the parts that I should get? I tested the original part that the brakepad sit on to cannot fit with the thicker ventilated disc (Is that part called knuckle?). The original 1.3 caliper can use for the thicker disc rotor?
Or do I need to change the whole part that holding the front wheel bearing? 

With Great Power Comes Great Brake Responsibility 

I've tried yesterday and the disc rotor could not fit into the knuckle where we install the brakepad. 

hello all the pros out there

my car was proton wira SE 1.5(A) ( 3 gear )

here is my problem, when i twist my key, i heard i small beep sound, but my engine cannot start.
all the lights , signal, aircond running well , dash board lights all function .. so i assume the battery is still good as no alarm rang.

so is that the starter problem ?

additional Q
how much is a original alternator and a recond one ?

that beep sound is from car immobilizer? My friend's car happened to be cannot crank due to that immobilizer intermittent problem last time.

how can i add on E-manage at my wira? where can buy it and where to install and prices ?

---

Added on August 17, 2011, 10:59 amhow can i add on E-manage at my wira? where can buy it and where to install and prices ?

nelsonlye, you have any recommended shop for chop shop to find those ARB, dogbone evo ? Also I find that when I'm at D with aircond on in idle, the car vibrating. Engine mounting ?

oh i had a gear rubber seal problem as well,my gear oil was leaking..changed two rubber seals,20 bucks each..major repairs are traumatizing..haha..but no more 'klok klok' sound now..next pay day ill change the rear suspension..