Ya..bt after a year do maintanance,he hav to sakit kepala again d..

no reset yet... the only way i will reset if i cant solve the current situation...

haih because my casing small.. big radiator no way put inside.. that's y outside lo at top.. behind also cant due to casing too pendek not full tower casing.

i will follow like lichyetan said.. the only way connect a long tube..

btw, wat bout those guy like DzX, Owikh84, they also set radiator at top rite? somemore 2 radiator....

how they bleed well.. owikh84 did mentioned to about their rad got bleed screw.. so easily bleeding...

maintenance is not every month wan laa .
me oso normally do after 6 months like dat .
i just love that after doing maintenance, temp sure drop 5-7C .
damn nice !

Haha..rad where u place also ok 1..d problem is u need to stop d coolant flow out frm d rad when u off that pump..d coolant wil flow out frm rad coz of gravity if dun hav pressure force that coolant to stay at rad.so if u can control d coolant flow out frm d rad is ok d..hahaha.

oic.... meaning after pump off... the coolant must still stay inside radiator la.. not half but full without air inside rite?
kinda hard job lo..

Yup..nt only d rad,d paip also need to full of coolant until d inlet at rev..coz at ur rev inlet there u dun hav pressure to hold d coolant flow out frm d paip..unless u everyday b4 u turn off ur pc,u blck that end of that paip,then u off it..hahaha...

if too much air inside the loop, then air will stuck inside ur rad when ur pump stop lo, if u bleed ur loop nice enough, only very minimal air will trap inside the rad if u long time didnt run the pump.

imagine, a closed loop, with a fixed volume.... u let the more air out, water volume will be more than air, hence less air will be trapped in the loop. So when u stop the pump, the coolant will remain in the radiator. But if u leave ur water loop off for few months, u will get some air trapped in the radiator, just some tilt will solve it.

But nw his inlet is placing at d top of rev..so d coolant at d rad wil flow out when d pump stop..Am i right?

he can just bleed with tubing method i mentioned, then buy a stopper/ fillport, fill the reservoir full while tilting the case. no need worry of air anymore... juz like wat vlad suggest...

oh..yup..bt it sound like more costly than change d inlet position.

bro is it your mentioned like this video?

http://www.youtube.com/watch?v=i18LBAjcsdI

btw, can i use the stopper provide by reservoir?

yup..d method almost like that..bt u u hav to buy d t join.

My new project, 80% completed

More pics soon

wow nice picture for sharing..
should i put my 20%? haha...
will uploaded my at september... now exam time soon..
no pc Y.Y

yuanbao...

no need wait la... fast fast upload it..

i also upload liao... even still got bubble and problematic setup...

rzs77 bro, u using bitspower res?

nice rzs77
another TJ's..

Can see red coolant there

yo abang owikh
y wts ur 480 gc?..

hehehe! thanks! just put lorh

yup! bitspower res. same like u

hahaha! how u know it's a TJ?

Wow bro, ur eyes so tajam
n Yeah...couldn't wait, tangan gatal d so just play2 fill

This post has been edited by rzs77: Aug 23 2010, 10:34 PM

artis tempelan. u asked supernothing to powdercoate TJ07 for RM100 mah