banda hilir, town areas should be able to get...
depends on ur technician how they check it...
do not trust the one that they check from TMpoint computers.
that one canot be trusted.
I went tmpoint that time they check, they say not support. but technician come and check . he said ok..
What they check is the :
1. Attenuation value.
2. SNR value.
If you can enter your modem/router page, go to Statistics or anything that can see your connection status.
SNR
SNR means Signal to Noise Ratio. Simply put divide the Signal value by Noise Value and you get SNR. You need high SNR for a stable connection. In general, a higher signal to noise ratio will result in less errors.
* 6bB. or below = Bad and will experience no line synchronisation and frequent disconnections
* 7dB-10dB. = Fair but does not leave much room for variances in conditions.
* 11dB-20dB. = Good with little or no disconnection problems
* 20dB-28dB. = Excellent
* 29dB. or above = Outstanding
Line Attenuation
In gerneral, attenuation is the loss of signal over distance. Unfortunately, dB loss is not just dependent on distance. It also depends on cable type and gauge (which can differ over the length of the cable), the number and location other connection points on the cable.
* 20bB. and below = Outstanding
* 20dB-30dB. = Excellent
* 30dB-40dB. = Very Good
* 40dB-50dB. = Good
* 50dB-60dB. = Poor and may experience connectivity issues
* 60dB. and above = Bad and will experience connectivity issues
Line attenuation also affects your speed.
* 75 dB+: Out of range for broadband
* 60-75 dB: max speed up to 512kbps
* 43-60dB: max speed up to 1Mbps
* 0-42dB: speed up to 2Mbps+
source:
http://www.dslreports.com/forum/r23051776-...ine-AttenuationSome old modem/router you cant see this values. But if you can, den you can fight with the technician back. =)
Hope this helps.
Goodluck in getting your 4mbps.