thank you. please read it carefully so u dun encounter problems later..

alan85>
can we meet this saturday at about 2pm so i can give u the gears??
and by the way, can we trade parts??

---

Added on March 22, 2010, 6:16 pmlolhalol>
ok i am half way reading it now.

---

Added on March 22, 2010, 6:20 pmthe double shafts of my hyperdash pro motor is shaking.
should i buy a new motor or stick with the old one??

This post has been edited by VIPER57: Mar 22 2010, 06:20 PM

get new one

ok thx

that's normal la, the shafts of all motors are like that. the shaft is made to move slightly inwards when u apply pressure on it, and then it will bounce out again. that's normal.

really??
thanks beans!!!
u saved my RM20!!!

haha, actually u can figure that out using other motors.
Even old single-shafted motors are like that.

guys since forum so quiet today.. discussion time.. what are your methods for reducing friction in the gear box area. I drilled out the plastic shaft of the green gear. i drilled all the way until got 1mm left . so only 1mm of plastic contact the bearing shaft.

what are your methods?

i stick to original one... but i believe stil can be fast... XD
U no scare the gear easy rosak ka? 1mm Lol...

but Aye... it's really big diff with that modding....

really save bett ~~hahahaha

soak in motor oil .

soaking in oil won't make ur car oily?
I mean when the motor shaft spins, the oil will spill out what...right?

his method is soaking the gear to the oil maybe for few days, after that take it up... clean it... dada... the smooth gear done~

damn quiet car lorrr. cannot hear anything one

quiet eh at t.u today??
i'll be there to test out my car at 6PM today.
yesterday i spend time about 1 hour just to setup rear rollers using red duralumin parts..hehe

dat part a bit weird..but nice!

got characteristic between normal frp+normal aluminium. just my opinion.

car wake up liao .

err soak in rc spray, later put lil bit of grease i suppose. make sure u have the best 520s u have in the gears and....run in the gears thoroughly. itll be smooth and quiet too this way.

tried to skim off some plastic before to "lighten the gears" but the outcome i think is too minor. cant even figure out whether its faster or not.

i think Ng's gearbox with the 9mm is something he should share with us all

This post has been edited by choycp: Mar 23 2010, 01:16 PM

Of coz it is diff... Jus nt the time yet... Stil workin on car 1st...

This post has been edited by TamiyaAye: Mar 23 2010, 02:50 PM

the most silent car made in Malaysia..

---

Added on March 23, 2010, 3:21 pmmy mod not really lighten the gear.. i dont think lightening the gears can do much. the gears already very light its negligible. as ng said.. for battery performance. good if using alkaline. the boost can last longer. either way its always good to have as little friction in every part of the car as possible

yeah ng. share ur bearing mod .. hehe..

This post has been edited by lolhalol: Mar 23 2010, 03:22 PM

imo lightening too much alaso not going to help .later if microfracture develop , habis . .. use la lithium but the cost, lol .