Of course send to SC to check la, if not u want repair by urself?

Small problem only, this part will worn after long period of usage and become the case u said, my old car before also suffer, don worry.

Happened to me twice just now...before this scenario, the car is hard to start, after start that, the engine act like what u said...it normally happen to me after hot engine start (means after stop for a while and start again). The RPM rise and fall is periodic one, like got rhythm one, just press ur accelerator for a while the car will back to normal.

This post has been edited by coolkwc: Mar 30 2010, 11:38 PM

This problem not transmission related. I'm using manual.

Since ur battery no warranty adi (>1 year), just tear away the sticker on top, open the nut by screw driver and add water. Our stock battery is 'fake' maintenance free.

Hey, how much for that? so the outcome is OK? brighter than ori bulb or not?

About the radius, different bulb got different filamen position, and the position will affect the focus point, thats why the radius also change. I learn this from the torch light bulb, so i think same case for ur car bulb also. This is my concern point, the ori bulb low beam is very even on road, just not enuf bright for me. I scare after change it will become uneven (can see the bright spot).

This post has been edited by coolkwc: Apr 5 2010, 12:02 AM

As long as the wattage is the same then should be no problem, else u have to change the stock wire if using much higher wattage bulb, becos the ori wire is too thin.

Guys, some info want to share wif u all...

Yesterday just managed to fix the vibration noise from my door, yes, both the front doors.

The culprit are all the moving parts inside the door lock, between the joint of the metal bar, door knob metal bar with the metal part attached to the door panel (don know how to describe, sorry if i make you confuse).

So wat i did was cover all the moving part edge with the small piece of sponge or stick some foam double side tape at the edge, so now the contact between those joint is sponge contact with sponge or tape wif tape rather than metal wif metal.So even it vibrate, you won't hear it anymore.

The hardest thing is to wrap the contact point without dissemble the whole structure, and you only got a little space inside, you have to wind down and up the windows repeatedly in order to reach that place, is hard to tell in words, you have to observe and understand by ur ownhow that parts working before u can do something on that, but it works, the noise finally gone since the 1st day i got my car. Tell you, i repeatedly remove the plastic door trim not less than 10 times in half year since i got my car on September last year

Again, no pic available...1st reason, i dun have camera, 2nd reason, i dun wish to open that trim again forever unless it make noise again.

So go to observe by urself, wind down ur windows completely, look for the structure, then use ur hand to slightly shake the metal bar (door handle horizontal bar and door knob vertical bar), u will notice there are alot of free play, thats the culprit. Next step is to observe the point that will contact with those bar, rape wrap it accordingly.

Since ur speaker is the culprit, make the speaker diaphragm stationary all the time will be the solution...

This post has been edited by coolkwc: Apr 5 2010, 09:59 PM

Try to think about it, do you think the technician there will fix it, test it, fix it and test it repeatedly? Try and error consume alot of time..

---

Added on April 9, 2010, 8:27 pmBecause my hand is small

Quite tough honestly, use almost 3 hours to fix it.

This post has been edited by coolkwc: Apr 9 2010, 08:27 PM

aiyo, 6 months? WTH...

no problem at all, dun worry...add voltage stabilizer AKA capacitor, change bulb no concern wif warranty...

40L is max volume, means nothing left in the fuel tank, i don think u want it to happen rite?

It will reserve 10L+ fuel when the warning light is out.

easy, just keep both of it, and ask customer when they want to change, let them choose themselves.

Personally i don't think the hard gear change got something to do with the oil itself but the design fault.

This post has been edited by coolkwc: Apr 11 2010, 11:23 PM

Tyre affects the most...so far i compare M-line with my B-line, M-line is quieter because of the tyre used. So test it out 1st.

Ya, if 50 R15 the circumference is almost = 70 R13 and 60 R14, so FC won't affected. But ride comfort of 50/R15 might affected due to shorter sidewall now.

This post has been edited by coolkwc: Apr 13 2010, 01:11 PM

As long as u can see the road and u never modified the light before, just let it be, why bother others? Is default setting, want to blame ask them blame Proton...i'm not selfish, but sometimes can't make too much tolerance on road.

The culprit is the mat stick on the trunk lit. They stick it out of place and cause the rubber around the trunk contact with the mat rather than the lit metal. Try to observe it, the water is come in from top.

I suffered this before, i told the SC thats the culprit, but they said is rubber problem. Nvm, free new rubber, they want to change let them change, after change i fix the mat by myself. Water proof now.

This post has been edited by coolkwc: Apr 23 2010, 08:41 PM

Sorry i dun know, but instead of find the way to disable bonnet alarm, why not just lock ur door by key? It won't last long in such condition rite?

This post has been edited by coolkwc: Apr 23 2010, 08:56 PM

New car always suffer this, i also not understand those idiot mind.

The price is standard if u service at Proton SC, so u are not conned. Ur oil is semi-syn...

Thick oil can give more protection, and it won't make engine 'dirty'...but in terns of car pickup, u will feel a little bit heavy compare to those 10w40 oil.

Petronas is main sponsor of Mercedes GP F1 team, do u still think this brand is so bad? What made u so bad impression on this brand? Out there alot of others 'unknown' brand oil actually very good in quality, so buy the oil that suit the engine but not the brand.

This post has been edited by coolkwc: Apr 23 2010, 10:17 PM