QUOTE
- Download and install .NET Framework 3.5 SP1
- If you are using Vista, install the Mobile Device Center 6.1
- Set up the ActiveSync (XP) / Mobile Device Center (Vista) connection with your X1
- Charge the battery to at least 50% or more
- (Re)Connect the X1
- Run X1_HardSPL.exe
- Follow the instructions (it should say something like "Image Version: 1.02.111.7" to "1.00.X1")
- If asked, press "Yes" on the X1
- Now a 4-color screen should show up, showing some version Info
- After that, a progressbar screen will be shown and the phone will reboot when finished
- Click "Finish" on the PC
- If you want to check if everything went fine, turn the device off (long power button press), then hold the "volume down" button and turn the device on again, still holding the "volume down" button until the 4-color screen shows up. It should read something like:
KOVS110
SPL-0.72.OliNex
MicroP1-787
MicroP2-707
- Remove and reinsert the battery to exit bootloader mode
You completed the first step and are now able to flash any ROM you want to your X1! (Well, at least any ROM made for the X1 of course ;-))
steps copied from xda-developer on how to HSPL
-since v can do sync our data alrdy, so step 1, 2, 3 could be ignore rite?
-make sure battery more than 50%, i think full is the best rite?
-(RE)Connect the X1, i think tis step is for those tat jus installed their ActiveSync or WDMC rite??
the following steps quite self-explanatory, ntg much to ask, jus, if any of the steps here didnt actually show up, den wat shud i do?
- Run X1_HardSPL.exe
- Follow the instructions (it should say something like "Image Version: 1.02.111.7" to "1.00.X1")
- If asked, press "Yes" on the X1
- Now a 4-color screen should show up, showing some version Info
- After that, a progressbar screen will be shown and the phone will reboot when finished
- Click "Finish" on the PC
- If you want to check if everything went fine, turn the device off (long power button press), then hold the "volume down" button and turn the device on again, still holding the "volume down" button until the 4-color screen shows up. It should read something like:
KOVS110
SPL-0.72.OliNex
MicroP1-787
MicroP2-707
- Remove and reinsert the battery to exit bootloader mode
v remove n reinsert battery after the previous "to check if everything went fine" step rite??
Added on July 12, 2009, 1:58 pmoh 1 more thing, does HSPL deleted all my contacts or msg?
This post has been edited by WindChaseR: Jul 12 2009, 01:58 PM