My table now

My Case Internals

Cable management at the back of mobo

current setup


My table used to look like this

some scary temperature of mine w/o aircond




This post has been edited by hahn87: Feb 19 2009, 07:55 PM

@koki,

i din't install the side panal fan scare alot of dust.

wow to bright is it u need something to cover u eye?

added 2 photo of SS ><

@abc.
either way u are getting dust =D
bottom intake usually brings in more dust than the side.
just clean it monthly then should be ok ady

@koki
i wish u gud luck cz u need 2 go 2 those F****** shop again..zzz

@hahn
finally post ur photo here...everyone post more photo of Coller Master stuffs!

omg .. too gay !

using same hp and i am =x


btw, your casing can improve more cable management

@hahn87,

i think you got to wear sunglass to sit in front of your pc.

as i said.. old photo... i did tidy up a bit more already
the pci-e power cable no choice but to be like this =/

hahn, got abit wasted u put ur casing under ur table...u r using laptop n desktop?

i got my laptop 1st coz last time use P4 old desktop... slow till kenot tahan ady.. then beg dad to get laptop since u can use in college to do work and all. it still follows me to college everyday tho.. without the notepal infinite lar.

i put at the floor coz dun have enough table space. + it's suppose to be on the floor. cables wont look so messy on table. more spacious. front panel ports and jacks are more easily accessible and i can put my phones on the casing

btw k750i is now my 2nd phone. the T630 now it's only an alarm clock.
just bought a nokia tube 2 days ago. along with razer moray earphone =D

@hahn87,

it just a reduction of dust by not putting the big side panal fan. plus i'm a clean fricke, i dust my pc every time when off my or b4 on my pc. The bottom fan i going to get a filter for it as soon as possible problely 2moro i will get it.

btw onnjeyyon i was on this leave since v4. when i got my CM690 that time this thread still v3. refer a bit from there. got post pic oso
and i did post CM690 photo of internal + cable management + whole casing appearance in dark in this v5.. u wasn't here only

I wanna change my Centurion 590 side panel to this:



(of cause only cut and add acrylic panel)

How? Any comments?

@abc
DO NOT USE DUSTER TO DUST UR HAF!!! otherwise the dust will drop inside instead.. even those static dusters are rubbish.. use vacuum with a small end with brush on it

Prefer clear sidepanel HAF like this



and white HAF ain't that bad huh.

@liuteva
if u use this side panel
ur graphic card cooler better be disposing heat directly outside the casing. and u have to install another fan at the drive bay. else. the bottom part of the case will not get good ventilation. bottom fan compulsary also

---

Added on February 19, 2009, 8:10 pmoo... milky HAF..
yea the acrylic side panel look nice.
but we concentrate more on air flow so original setup would be better

This post has been edited by hahn87: Feb 19 2009, 08:10 PM

wow .. senior member chyu89 has arrived ..

unless u go water cooling like the pic u posted.
that's look like a BGF tech H20 version of graphic card

White HAF so sexy, but the front CM Logo there feel strange.

Mine is Centurion 590, bottom no intake fan one. Summore i hate side intake fan also, its alot dust stick there

haha depending on graphic card u can setup the side panel fan as exhaust