Overclocking E7XXX Series
|
|
 Apr 3 2010, 04:46 PM
Return to original view | Post
#101
|
 
Senior Member
3,427 posts Joined: Apr 2007 From: Gangster Paradise  
|
u cannot go higher fsb? how bout pump some more volt on vcore or try pump NB voltage little by little..
my EP45-UD3L can boot 400Mhz easily but with x9 multipler.. u can try tat.. lower yr multipler and see can boot onot.. i did not try x10 multipler cz 3.6Ghz was my target tat time.. but i think i can go higher by adding more voltage.. |
|
|
|
|
|
Apr 6 2010, 08:43 PM
Return to original view | Post
#102
|
|
Senior Member
3,427 posts Joined: Apr 2007 From: Gangster Paradise
|
1.45V to get 400 x 9.5 is kinda high, its quite a big jump from yr 400x9..
 but anyway, good try..  load at 70 for prime95 is bit too high, but cz yr vcore is high, so i think its ok.. try run linx with that setting and i can guarantee yr temps will shoot above 90..  |
|
|
Apr 7 2010, 10:23 AM
Return to original view | Post
#103
|
|
Senior Member
3,427 posts Joined: Apr 2007 From: Gangster Paradise
|
QUOTE(JoBigShow @ Apr 7 2010, 01:25 AM) I think with Linx, the guy's temps might reach 100c with kind of Vcore paired with air cooling... yup.. linx temps r indeed killing.. And if so, it will reach TJ Max and auto-shutdown during Linx test-run rounds  @deep_hunter no need to try Linx if you are patient with using prime95, Linx makes the long hours of test in prime95 done in half an hour or more, but will rev-up your E7200 temp very high. Btw, are you sure 1.45v is the lowest you can get stable on E7200? Try lowering it by increments until you stumble on errors during prime95...I hope you can get lower bro..1.45v is indeed an unhealthy voltage for the 45nm proc...  i run prime95 at 56 max, i run linx reach 71.. tat's true, 400x9 is way better than yr 400x9.5.. try to do some fine tuning if u wan to for yr 400x9 settings.. |
|
|
Apr 26 2010, 08:40 AM
Return to original view | Post
#104
|
|
Senior Member
3,427 posts Joined: Apr 2007 From: Gangster Paradise
|
wat do u mean unable to boot with those 2 mobo? is it new? u can onli boot up with GAEP43-UD3L? yes, a C2D is suppose to be better than a PDC..
This post has been edited by farscope: Apr 26 2010, 08:40 AM |
|
|
May 4 2010, 11:42 PM
Return to original view | Post
#105
|
|
Senior Member
3,427 posts Joined: Apr 2007 From: Gangster Paradise
|
QUOTE(dvinez @ May 4 2010, 05:35 PM) e7400@3.5ghz decent.. idle temp bit too high, stock cooler?333 x 10.5 1.25v ram 667mhz fsb:dram@1:1 idle cpu temp@45C peak cpu temp@60C ok ah ? |
| Change to: |  0.0299sec
 0.36
 7 queries
 GZIP Disabled
Time is now: 20th December 2025 - 09:52 PM |
Quote