If i am not mistaken right,if you put a fan on the side panel's acrylic,you will find out there's a vibration.So,it will make a noisy sound.

i screw it tight tight also got noise?

They will be a vibrations.

try to source for low rpm and silent fans to overcome this vibration problem.
you can also get the vibration damper kit to fix for the 120mm fans.

as for the side panel, make sure the screw was tighten.

very frequent that with the used of high rpm fans will have louder
humming sound.

rgds

thanks for the advise.. but i bought the fan edi. 120mm.

---

Added on May 31, 2008, 6:13 amthis fan how many rpm?

This post has been edited by danieldotcom: May 31 2008, 06:13 AM

jus put rubber washer bro if u think will produce vibration


@danial
u got any intake fan dy?if not u can use the fan u wanna build on sidepanel as ur intake fan

the original fan intake from the casing it self. very small fan. so i decided to build the fan on my side panel. but i dont know how to cut it. after so many advise and comments from the PRO, i think i know how to install d. thanks

master? hah, i felt like my hand been swollen after finish cutting 2 holes

yeap,really noisy...
me using zalman n CM silent fan but still make a noise....
make 4 120mm hole on acrylic...
u can click here for my worklog...

This post has been edited by irienaoki: Jun 7 2008, 01:46 AM

Jigsaw will do the job then u can smooth the edges using the dremel tools...

bro, thanks a lot. i learn a lot from there. how bout put some cotton there? will reduce the noise?

cotton? how about put some rubber washer.... sorry for wrong spelling..

use hot knife or hole saw set

burn the knife? serious?

getah paip bole?