Hi all,
i got problem with this casing. i want to make a hole in the transparent plastic, so i can put my fan there. but i got no idea how to "open" a hole there. please advise.

i want try to use pen knife, my friend say cannot cut wan.. sure make the plastic got scratch.. summore i dont have tools to DIY. anyway thanks to MFCM and renesisx.

OIC.. like tat hior.. lucky dint start cuttin with pen knife.. else my casing habis.

thanks bro.. will post my pic after i mod

on the side, the transparent side. put 2 pcs of 120mm fan there to blow GC and processor. Top and btm.

have to get a better pen knife. btw, blow in better or suck out better?

i screw it tight tight also got noise?

thanks for the advise.. but i bought the fan edi. 120mm.

---

Added on May 31, 2008, 6:13 amthis fan how many rpm?

This post has been edited by danieldotcom: May 31 2008, 06:13 AM

the original fan intake from the casing it self. very small fan. so i decided to build the fan on my side panel. but i dont know how to cut it. after so many advise and comments from the PRO, i think i know how to install d. thanks

bro, thanks a lot. i learn a lot from there. how bout put some cotton there? will reduce the noise?

burn the knife? serious?