Hoho, coz now in semester break. So this break go play with the card and change the cooler, pretty impressive compare to the previous cooler.

So is there any OC attempt by the sc478 members? Havent been login since the past week coz at home no internet, now surfing from CC.

he didnt know that i think. since he mentioned that these days no internet.

sang_karim, your did your si120 near to northbridge sink?? mine quite near and hardly put a fan on it. i have a TT 60mm fan, planning to put it on.

@sang_karim
as your hfs almost like mine, so just want to ask. as my northbridge is hotter than my cpu, so think of a way to cool it down.

sang and fylon,updated your profile in the first page already.

@sang,nice o/c you have and the Super PI is very good.Congratulations.CAn be almost par with fylon.

I bet you can do better than fylon if running at the same speed with him.

Wah, sudah V5.
Kuatnya korang SPAM.

Anyone here has beaten my 4GHz mark?

Woh? I was now typing this reply with 4G and also use the same setting as urs! Was try to do some 3dmark benchmark later on. By then, had u try with vdimm 2.85v see can boot or not..

I just found that my proc need 1.5v vcore to stable in certain task such like file compressing.

Haha.. Yea! 1.5v needed to some do application. But just for testing purpose. I wont stick to 4G all the time as well. Normal usage, 3.6G is more the enough.

By then, the ur game isnt finish yet.. Tried with 5:4 timing yet? Maybe 1:1 ratio will hang u at 255fsb but 5:4 might able to push ur proc higher without depend so much on the ram.

THis is strange,i think maybe your RAM doesn't like loose timing at low frequency.

maybe thats true. raymond, your ram just pass a message to me. "DONT UNDERESTIMATE ME!!! I CAN RUN AT TIGHT TIMING~~~" jk jk

wahahahaha.....mine last time have face this problem, running at cas3 dont boot at all, at least must run at cas2.5 or cas2. that time was running at speed below stock speed. once get over 200mhz, then running at cas3 no problem. but also quite useless, cant even get pass trought 230mhz.

@sang_karim
you try run it at 5:4, i think you should get higher. since you can get near to 3.8GHz 1:1, i believe get pass 4GHz with 5:4 is not a hard work. at 4ghz you can run at 2-x-x-x timing. i htnk the performance will be better than your current 3.6GHz

Wah... 1 hrs dint refresh thread is flooded.

@sang_karim
Haha.. I never tried with 5:4 before as i can hit 4G with 1:1 ratio i think it should be enough for me. As for the timing 2.5-3-3-6 @ 4G i gain around 7k bandwidth for my system. Most of it, as Ray & kabu has says, ur ram need to be tighten up during high speed. Btw.. Ur proc hit the wall already wth 255mhz @ 1:1 ratio? Not done yet.. Maybe vAGP not enough for high speed. Since u had pump more then 250mhz.. vAGP might be one of the concern which limiting u get beyond ur current speed.

Haha.. Sorry! Got flooded with game on mind. Owh yup. Tried that before actually, due my ram was PC4200 = 533mhz but unfortunately i cannot boot my system what that setting. Thats why i stick to 400mhz.