Hi,
Does anyone use those Engine Treatment Oil like "EngynProtect Pro (EPP) or Estremo" products to Flushing Engine, Treat Leaking caused by Aged Oil Seal or O-Ring... " to reduce Engine Oil Burnt problem or Engine Oil Leaking?

Go get it fix la , later want save abit end up with big bill .

As you already know Oil seal/o-ring wear out and engine oil leak through it, how can you reverse it back!!! make it grow back like bones!!!

If a properly maintained engine start to leak oil, normally you change to a thinker engine oil... e.g. change from 0W-20 to 0W-30 or 10W-40 etc...
If the leak still continues, then change the seal/o-ring by a good mechanic. Next is overhaul with top first then full.

Forget about those Treatment Oil, all snake oil

Thanks for advice!
Now was using 10W-40, oil leaked from Gearbox & Flywheel weren't so bad (floor no mark) but Engine Oil Burnt is quite serious! Old Old Car 😅

if engine is very old can try use it, why not. it's high viscosity will raise the engine oil viscosity a lil so thicker n heavier oil will leak slower n lesser at low rev low temp. observe white smokes from exhaust if it reduces. it doesn't justify to overhaul a very old engine unless u suddenly got loaded n plan to restore it

can try STP's high mileage engine treatment+stop leak. also try using 20w-50 by next oil change

15 yrs, very old, haha.
So far no White Smoke.
29W-50 super Kaw, must be very heavy like tarik cow 😁

never put those in your engine bro...

the only way to clean your engine is to overhaul it...

or

u can try visit workshop that can do flushing technique...but those only clean your combustion chamber and exhaust part ( not your exhaust pipe but the part before manifold )

If leaking from the gaskets and seals, and is visible on the outside of the engine, all of those are replaceable and cost much less than an overhaul.

If the engine oil is burnt and exist the exhaust as smoke, then you could have piston ring, combustion cylinder or valve wear. These needs overhauling.

No amount of oil plugging additive can solve that.

tarik cow better than engine burnt out tarik tow truck

Appreciate your advice! P
Lately, Oil Burnt seriously but no "visible" smoke like white smoke blowing from exhaust! Indeed, there's burning smell from exhaust after car was started!


Hahaha ... Definitely 😁

So. No one's try those treatment oils before?

been using engine treatment for decades. if no improvements aint recommending. wanna top overhaul up to u

What engine oil are u using? Brand? Original?

Wow... Finally got 1 positive feedback 🤣
Which one you are using?

Castrol, App to update for points everytime purchased. So, should be original

Yeah after 260k km just replaced top gasket on diesel turbo. No burning engine oil. I use the cheapest mineral Caltex Delo 400 or Mobil Delvac.

So, it's consider a Top Overhaul?
How much it cost?

You can try to use two bottle of bardahl no 2. Bardahl is a brand long time in Malaysia. But then is fixing symptoms only. If want to keep using car better check properly

15 y/o car... what's your plan? Continue for 5 more years or already looking for replacement.

If decided to change car then can play with the treatment oil for fun while waiting for new car arrival.

If continue to use then look for a good mechanic and ask them to check what's causing the leak. Here in /k all guessing only.

Changing gasket is around rm100+/- as I don't know your car brand. If its Merc/BMW then another story