I'll start with my regrets

1) too many downlight (in which over the 8 yrs of living, didnt really utilised much of it)
2) bed frame without stand, dirty at the covered bottom and always hitting the bulky edges
3) didn't change my whole house's piping, still using GI from developer (too naive to trust contractor at that time)

1. un-even wall
2. bad workmanship
3. wood ktichen - should do tile and cement kitchen
3. fully white and black theme - easy dirty while black easy stick with hand print
4. too many tile - should consider epoxy and coating for certain area

wait till anai2 eat all ur wood cabinet ~

using tiled roof....

un-even wall is kinda common among contractors

1. Did not choose a bigger sink, mine is 60cm x 45cm, I should've gotten the 75cm x 45cm.

2. My downlight is still too close to my ceiling fan, causing shadow chopping effect.

3. Not enough plug point

Not enough down light for wet kitchen

Kitchen table top is L shape, not user friendly at the L corner. Should have made angle corner

Didn’t do tinted before add grille

This post has been edited by kennykck: Mar 7 2023, 12:34 PM

how many you have? in what size of wet kitchen?

4000k downlight?

should have asked the contractor to pull dual water supply (city + tank) to my wet kitchen sink, so that when there's a water cut, can still use the tank water to finish the washing

can still do bypass with one way valve

may i know how to do this bypass ya?

Something like this, depend on piping system at your home

i see, but i think this is like by-passing the tank instead?

for me, i would like to have the tank water to come to my wet kitchen sink instead (currently is direct), with a separate stopcock below the sink tap so that i can do the switch over when needed

Same concept, just need to change direction of one way valve from tank to main pipe.

eg: No water at main pipe(low pressure) > water from water tank will push (pressure) > one way valve (open) > water flow through main pipe

Again, depend on piping system maybe need to add another one way valve. The point is, can be done la

Mine
Not enough plug point
Didnt do copper and drain outlet for aircond. Only do wiring lol
Floor tiles deep cleaning and polishing before move in

i see, ok get what you mean. let me talk to my contractor. thanks a lot

1. for this round, i will get a bigger one for sure, forget about dual sink at wet kitchen, less advantage than 1 single
2. i try to minimise my downlight, gonna use more track lighting
3. will add like mad for this, every damm corner

will research on angle corner table top, but i will be doing concrete top most porbably

yupe, this is a requirement i told my plumber.

point noted for the copper and drain outlet, so far i will prepare wiring but the location is just backwall of the house, so drainage shldnt be a problem

only 1 in the middle of kitchen, but it cast a shadow when chopping food. cool white light

didn't skim wall before apply painting. now have to skim and repaint again

U can still DIY add more lighting.

Just get plaster ceiling saw, some wiring for looping and cutter to cut the metal holding plaster ceiling (if any)

purpose to skim wall is if got uneven wall. u dont need to skim if its good.