Dec 2 2008, 11:30 AM
QUOTE(NxNSquares @ Dec 1 2008, 09:45 AM)
Bad idea to spray WD40 (or CRC808 Silicone Lube) onto the core's thread as that wouldn't give you a good grip over the screws resulting inconsistent springs tension.
well not really it is advise to use silicone rather the WD40 because contain Liquefied petroleum gas which in result dissolve you cube which may break the cube`s core if you spray it too much.
but in certain amount WD40 is good to break-in a tight storebought but becarefull to washed it thoroughly after one night to let it stop corroding. .
the inconsistent you talk about can be easily be be avoid by randomly scramble for 5 minutes or so to even it or just a simple change of tension on a DiY.
cheers.
This post has been edited by Mr.Ace: Dec 2 2008, 11:32 AM
Quote
0.0272sec
0.29
7 queries
GZIP Disabled