Expxy flake coating. Cheap and easy. Looks nice, not slippery.

I did for mine also.

looks like outlet of sink.

check the floor there for any gaps.

just use this one cheaper,
spray the whole area only

SOS KICAP

not bad, looks nicer than raw cement color

is it? i also thinking so. may need to check the gasket / seal in between.

wow. this macam yes. try before?

above is a toilet floor ?

then you also need to seal the tiles grout and the floor water pipe outlet top /sides.. water can leak off here.

below can do that .

https://shopee.com.my/Sika%C2%AE-Sikagard-7...1301.5410310649

no. check the part where the pipe goes to floor

that pipe is uncut . from top / floor level to the angle join below .

there is no gasket/ seal in between .

my guess .. that leak is a floor leak . the grout between the pipe and toilet floor .or immediate surround ..there is a square plastic top .

there is no way to check this .
so just apply the sealant at all the grout and area around the pipe at the floor .


This post has been edited by Momo33: Apr 16 2021, 12:45 PM

roger that. so i need to apply sealant to close the gap between floor n the pipe / floor trap. gonna to try this first.

I also facing the problems like you. But my problem is the pipe connecting to upper condo unit toilet bowl. I also headache don't know how want to solve. Already complaint to management

hahaha. now im thinking, are you staying below my unit? haha. cos pictures are front the unit below, complaining leaking from my unit.

The water proofing is supposedly done above floor where water leak from. Not your floor OR trying to do sohai method of waterproofing your ceiling from bottom.


This post has been edited by Syie9^_^: Apr 16 2021, 02:03 PM

i'm the unit above. my unit leak water to the unit below.

Ok. then all you need to do just hack all the tiles, water proof it then with importance to drainage outlet.

the rest just peanut.

Also I just noticed the yellow pipe flange, that suppose be at your unit not below the slab.

This post has been edited by Syie9^_^: Apr 16 2021, 02:12 PM

i guess i will try seal the grout first. if really not working, then no choice but to proceed with hacking / epoxy.

yellow pipe flange is at my unit. correct.

All waterproofing must do from the top.

If it is the roof tile, then do it on top of the roof tile. If it is a concrete slab, it must do on top of the slab.

For DYI cement, you can purchase premix water proof cement to fill the gap. Clean the gap. Then pour dry cement powder into the gap, use a brush to compact it as much as you can, remove the excess powder and hair spray water to wet the powder.

you need a small brush to apply the sika sealant. if dont have .. an old tooth brush that have a sharper front edge is fine.
apply to every grout within 3 feet diameter, the cement joint s around the square plastic top surrounding the pipe. and every cement/ joint you see.
plus the wall/ floor edge surrounding the outlet.

wait to dry in 1 hour ... reapply the second coat . i am sure this will fix the problem. i had similar case.

if still leak ...do again... and apply to the whole toilet floor grout areas and all the wall/ floor edges.

i have even seen water leak out of the concrete beam in the room next to the toilet . due to a toilet floor leak.


after 6 months / or when necessary you need to apply again to restore the water proof.
that 1 liter bottle can last many years
do feedback the results.

This post has been edited by Momo33: Apr 16 2021, 02:52 PM

Thanks bro. Using this right? Will give a try.

https://shopee.com.my/Sika%C2%AE-Sikagard-7...1301.5410310649

this settled