thats the price for plus version
yup, now the price already drop down, but this is based on the 3rd week of last month price list. i dont know if the price will go up again, but i hope it will not because im planning to buy a case too

anyhow here is the pic from the ATE price list



@doom

thx for that price list hehe, you are much faster hehe.

go to their shop and ask for a piece lah . . as simple as that ..

this digitalized version is contribution of our forumer that went collect it and scan into a digital copy ...

u can call ATE yourself and ask them to post it to you

U order the gfx fan oso no use coz the plus version has a vent on the side panel. Non plus case doesnt haf a vent there so it'll just recirculate hot air.

1st
2nd
again 

there were once a penang kid stating he bought one case from ATE--> he call ATE

then ATE post it using Pos Laju/GDex or God knows what courier ATE using

ATE = Advanced Technology
wah, like dat ar

baik xpayah beli  

like dat better buy in the Bulk thread

price = RM280 (with transparent side panel)

retail lagi tu

Ya the holes are there for bolt on fit of the gfx fan. U just need to cut the acrylic then. The v series side panel dont play play, damn blardy hard to cut coz of the super thick aluminum. Only try it if u have a good strong professional quality jigsaw. Inter Asia is not ATE. Inter Asia is Silverstone distro, ATE is Lian Li.

If im not mistaken, the price is still RM35.

The price for the bezel from ATE is rather expensive. I've checked at various US online store, they are selling at around US$6.   

My bro in Singapore also told me that he can get from SLS for around SG$10...

Christmas mah, cheers men.....  

This is what i did with a non modular PSU....

cable management is challenging but not mission impossible ..... 
I think slightly less than RM800.....

It should be V2000+, actually all V series sell by ATE are plus version ..  
I was one of them that saw and grab.. too bad didn't able to grab more than one box .... arrr
Black double sided tape would do just fine, it's industrial grade if not mistaken so cost about RM12 per roll ... 
ATE .... however need luck if got stock or not 

lian li v2000 , anyone use it here....

woot , i aalmost nuy dis casing las week...

but money short rm 200  

actually double sided tape is fine to use...

but if u worry too thick.... then epoxy

White tape isn't strong enough at all ..  I tried myself before ...

only those that has very strong adhesive material could withstand small hit impact ...

@cschun86

hmmm .... I don't think there's any other method than using strong double sided tape..

If u could find some hex head bolt and nut ... that would be sui sui .. can polish a bit and shine gao gao ..

I'm using it now, but I got it locally at UK ... hardly seen any in malaysia..

As for the exterior just prepare a pail of cleaning water and add some laundry detergent and soak the panel or whole case into it for couple hours ... make sure to remove all the screws and I/O connector .. .

It should bring back all the shine of aluminum case like a new one.. . .

hahah ,, yah men .... I used those babe wash pail that is big enough for half of the case being soak in each time ..

so take about half a day to get things done .... because usually I would polish every part of my PC bring back its shine as well ...

so by the time finished with cleaning other parts, the case is about ready as well ....

hmm .. usually all the parts could be removed ...

which case are using now ?

if not mistaken the power switch can be removed .. I remember I did it when I was cleaning my V1000 before .. it's a bit tight and u need the right length of screw driver to reach it ...