Boss, how much for a wc like this?

current market price is less than rm 1.5k, but u nd to make sure the hole distance is 300mm

I'm curious how to tell the hole distance - Without actually dismantling the toilet bowl, is there a surefire way to know what is the hole distance from wall?

Is there diff hole size (diameter) to be concerned of as well, or the hole is always standard (1 size) only?

depends on the aesthetic of the previous toilet i guess.

some toilet you can clearly see the s bend without dismantling. then just measure from the wall the distance, from wall to middle of the hole would be the distance.

as for hole size it is always 4 inch diameter.

hole diameter on the floor standard is 4", usually need to remove only can c unless u have an old design where the pipe is visible

Any recommended shop to shop for toilet bowl?
My contractor suggest this : https://www.gsthardware.com.my/

price seems not bad, but only carry johnson suisse brand. is johnson suisse good enough?

also any good recommend for under RM800?

This post has been edited by neo_6053: May 16 2021, 04:01 PM

how long warranty and if spoil got contractor can repair?

internal tank fittings 2 years
Other parts 1 year

they got service team

Hi, i just want to share my problem or maybe you can give some advice please . I bought a toilet bowl s-trap livinox brand. This bowl, when flush the water in tank will built up with the waste before slowly discharge away. Some other toilet bowl when flush the water from tank will push the waste to discharge. The problem im facing is this bowl frequently blocked, i think it is because of the design of the discharge method or is there any other reason?

may b u using symphonic flush design.
1) either u put too much toilet paper
2) may b installer didnt install properly, as the outlet is 2" (standard washdown 4") if they didnt install properly and caused the 2" outlet to be covered 1", thatz y cant flush out properly

I am about to replace my WC and found this. Great.
Both Johnson Suisse & Sorento can easily find replacement parts?
Can recommend me a budget WC with the following factors:
- Budget < 1k. Cheaper better
- Easy to find replacement parts
- Good quality
- P-trap

Anyone has installer contact and how much is the market price for WC replacement labor cost?

u can look srtwc8319 my best seller


plumber rates rm 180 - 250+- depending location

Yes, get the one piece toilet bowl with UF cover type.

I prefer to this also

can anyone recommend wc that has water inlet from the top instead of the bottom of the flush tank?

noticed that most modern wc has water inlet from bottom but my experience when flush tank is dirty, the water will backflow into the cold water system of the whole house!

if u have water keep coming in (there is pressure) water cant backflow. Moreover the tank is only 6L, there wont b much pressure to backflow. Moreover water is coming down from the tank, so the tank water cant go against gravity upward into whole house system.

anyway if worry then jus add a one way valve at the inlet

thanks very insightful =), the problem is that this apartment water is from bottom, meaning the pipe for the unit is running on the floor instead of the ceiling... is this normal?

my cold water has chemical smell and taste, dont know where it coming from a

may b old apartment using metal GI pipes, try adding a carbon filter near water meter if possible. BUt if pipes inside your house also metal pipes then no use. I saw some online add for pipe cleaning, that might help.

https://www.facebook.com/watch/?v=136690804293382

ya, me too! pic please

I was wondering where the best place to get TOTO toilet bowl in Klang Valley. I been to Top Idea jalan ipoh, is it me, TOTO toilet bowl is quite small, like a bit narrow when sit on it.

I am in a hurry to get a toilet bowl, hopefully this week.