Listen to the guy who says call kdk. They will send someone to balance it FOC if within warranty.

Panasonic and KDK both did that for me.

kasi screw semua ketat ketat

that one also need, fix fan is most simplest job. All you need is the ceiling hook, a ladder and a screw driver.

Really? Not they install wor. Got charge??

Ok bro...will try. Thks.

This post has been edited by Matrix: Aug 30 2017, 10:47 AM

Ko cuba tgk installation wiring kipas tu ada tak satu dawai dia skru jugak?
Kalau takde bende tu ko kena cheat

Dun understand. What wiring kipas? You mean wiring at the ceiling there???

2nd and 4th same with 1st and 3rd or 1st and 4th, it is to make sure that the weight distribution re adjust
there is another thing that may cause wobbly, simply go up and check all the screws were tighten CORRECTLY so to avoid wrong alignment
tape a coin with the tape wrapping over the front blade is safe

the nut too tight. the technician shouldn't tighten it as it will not have any free space and it will wobble. normally just screw it until pass the hole and insert a secure clip as to not let the screw being screwed out in the long run. many unexperience technician will screw it tight and did not put a safety clip/pin which comes together with the fan. there is also another safety wire which can hold the fan in case if it drops down. touch wood will not happen

not the fan's fault
the technician did a lousy job installing it

U take tangga and panjat turunkan cover kipas yang atas tu. Yang bulat tu. Dia boleh slide down. Bila turunkan akan nampak wqyar sedikit neutral earth live. Ada satu dawai sepatutnya di skru. It must be screw.

Bring to foreman there do alignment and balancing

Buka the case and see what's going on

When u hold screw driver u know what u want to do. Trust me.

But mine is 5 blade....not 4 blades...

classic stuff when exchanging old kipas to new one

they malas to change the mounting n use the old , harden rubbers which no longer "gives" to new rotating hence wobbly

The blades are easy to detach using screw drivers. Just swap one with the opposite side until u find a good balance.

Do balancing by adding a little weight on the one that u suspect underweight.

https://www.youtube.com/watch?v=yuBI10xTRxA

Adjust the location of the weight to balance it, ( nearer to the center or further away)

This post has been edited by ctrl_alt_del: Aug 30 2017, 11:03 AM

do not tighten the nuts which hold the U on the ceiling. it is meant to be loose and it has a safety clip\pin to prevent the loose not from coming out.
when you tighten it, the fan will get wobbly as what you are experiencing now

Many ceiling fans come with balancer to be fix on blade but normally not needed. I would say the installation was poorly done. I installed all fans on my own. It is not that hard.

Call KDK office. They'll send someone to come and make the necessary adjustments. FOC

I think i saw he replace the black thing in the U near the ceiling there...is that what you meant?