Seriously I think Huawei E5186s-22a is overated. I'm perfectly happy now with Huawei B310As-852. Way cheaper than 5186, no carrier aggregation. But can connect to LTE band 3/7 and 8.

Consistently at least 20Mbps. It's nothing to shout about, but more than enough for average user like me.

Which mean it memang like this ?
Anyway to make it faster ?

did you ever try to power on 790S without battery ?

Tele2 cannot use telephony function while Telia can.
By the way, how do I disable the IPv6? It doesn't work well with some of my sites. It's enabled by default.

Because 3g can either have voice or data. You can't have both.

Oh is it? My data don't work as long as  I am in call. I am actually using infinite 150 in a phone.

is it limited by hardware or firmware? any possibility to mod this out?

Couldn't agree more. at least i still have my streamyx to fall back when digi is congested, although that beats the purpose of using digi as replacement for streamyx.
Was told by technician recently that unifi is going to available in my area soon, but i will never take their words seriously. 

Anyone here able to enable PPTP or L2TP connection using another router with i150? The purpose is to get a public IP from VPN.
It seems to be blocked. I tested with Unifi and no problem.

Means the hardware/phone maker need to ask DiGi what is the configuration and then put into their firmware during upgrade. Very specific support needed.

But I still need to have correct model right? I can't simply flash it to any phone. Or modem.
That's because DiGi did not update their website.

What band are you on?
Install network cell info app on your phone and look for cell towers nearby. Aim your antenna towards those cell towers, check from huawei toolbox, the Cell-ID. Note the congested cell towers. Restart CPE regularly whenever you detect that the congested cell towers are connected.

I can detect about 4 cell towers at a 120degree angle from my balcony. There are cell towers around 1-2km from my balcony. The best one is the furthest. It is located around a lesser populated area and also near a highway.

2 of them are shit, Band3/7, 1 of them works great at Band3, 1 of them at band7. Whenever I find that the bad cell tower is connected, I restart the CPE and most of the time, the good cell tower is connected.



Upgrading to Lte-A is costly and does not reliably yield good results
Best method, most of us here find, is still tweaking between band 3 / band 7, and adding the MIMO antenna.

yes. every one contribute 150 like crowdfunding yoh,,,,

yesterday i asked for refund from digi.

but of course they would not give la....

truly agreed.. 3CA network still in vague and unmatured.. 2CA is fine enough..

if like that, do you have idea, how to protect our consumer right? As i know, only SKMM this channel to let our consumer voice up and complain only....

Must be place dependent.. My place not even a LTE-A covered area but still can capture the signal n force it to lock to 4G+
In my case I'm using Samsung phone tethered to tp-link router.. At perfect place and angle I am able to capture both B3 and B7 to use lte-a.. E5186 is a powerful CPE and I believe it has more capability than my Samsung phone.. Just need to find the sweet spot for it

yours if not mistaken is ac790s right?