senior member, but not senior citizen.

i just don't spend my weekends inside shopping complexes

few weeks back also added this to the garage.

the new aquatak 100


the short lance is very interesting.


IINM in bosch line there's never been a short lance before.
i really hate the (unwieldy) long lance that bosch (and nearly all other manufacturer) ships their pressure washer with. tis the reason i don't take out my aquatak often.

was contemplating to buy an engine pump/engine washer but it takes space. prefer something narrow to permanently mount to the garage wall.



the aquatak 100 with the narrow body and short lance is too irresistible to not buy.

the 100 bar is quite weak though.
my aqt 37-13 has better exit pressure. this aquatak 100 don't have enough pressure for rotating nozzle.
then again the 37-13 is rated for 130 bar. 30% more power. oh well

too expensive already.
if near rm1k i prefer engine washer with separate motor and compressor. can replace and change individually.
china units are sold for around rm700-ish.

what brand of mitre saw you buy? sounds serious qc issue.
mitre saw or sliding mitre saw?

new addition to the garage




now what else to buy and fill the garage with. still got some space

nope.
too far north from cthardware.

move to a rural area and build yourself a house with one

thanks.
haven't use it much been busy with the 3d printer building robots

it's been raining cats & dogs lately.

so go buy a waterpump to pump all that excess water out.



this 3" direct drive pump with attached impeller & housing i think produce better flow than normal 4" flex cable impeller.

i think i want need a generator next.
maybe a diesel generator. yeah that would be nice to have.

no lah.
that is a paddy field. too much water distort seedling growth.

i now work as rice farmer.

self priming

well this looks like a nice little tool to add to the garage

a merc is not a tool.

this however, is.


2.0 twin turbo 10 speed auto
same engine & gb used in raptor. (nearly) identical gb used in f150 raptor

skip the gdr120 plis.



weak torque. slow speed. no umph.
far cry from higher end impact drivers.

ya 200bhp and 500nm from 2.0 is jawdropping
hopefully raptor aren't priced at 199k

got a comment in pauline saying gonna be much lower than thai price.
180k raptor fuh

you're gonna be dissapointed.
180nm is pretty weak to undo tyre nuts.
especially if they tighten using those pneumatic impacts. those are rated upwards 500-600nm

my gds250, rated at 250nm won't undo them.

sadly no, this 35000 sqft plot is not my backyard.


but this 70000 sqft is

moving out from KL to back country is the best decision ever

photo op no wear eye protector mah kenot see my handsem face

he came twice and spent the night here

this past few month he's busy with that taiping project.


and i'm busy with 3d printer and robots-es

my HT room still KIV with no ceiling bwahahaha

you got open a nursery?

i foam wash them. or pressure wash.
but i really do.

never had a problem with water seepage or wet coil or can't start

cos i do my own maintenance, repair and overhaul

i don't wash my chain.
i soak them in gasoline or diesel to break down the tree sap.
then brush them clean.

then spray them with white lithium once they're dry.
well if you consider white lithium as oil