Hope can increase build speed by x3 with this...


Attached thumbnail(s)

I saw this at gamers arena, how much was it again?

bought it for 4800yen plus 300yen postage.

no idea how much GA selling.

This post has been edited by advocado: Sep 26 2017, 09:16 PM

Is this your channel ? the ZZ looks awesome, a must buy indeed

My local shop sell this at rm240+..
Gotto hando!

hah means i saved rm50. can buy another Tamiya Mini 4WD!

Not my channel just browsing to check out the build, but probably skip this one since I don't really like zz design

Is all the God hand been onesided nipper? Will it really help to reduce nub mark and sanding? I almost get it when I saw it in gamers arena last week but the price is rather high

mine is both sides.

the 1 side has slightly different code.

but does it help to reduce nub mark and white stress mark?

i haven't used it. both sides are sharp, but only 1 side moves when you grab it.

people saying it does cleaner cuts, which means smoother cuts closer to the surface. minor sanding might still be required but saves more time.

stress mark usually done when the cutter "pulls" the plastic when cutting due to not sharp enough. so i'm guessing it will reduce stress marks too. but it's good on parts cannot be sanded like special coating parts.

if someone has exp would be good if can tell us the do's and don'ts as i read you can damage the godhand.

the one sided blade design actually works that is why China has been copying the design as well. Unfortunately, the price of Godhand before is acceptable but right now, even without mark up, it is really expensive.

I have bought mine 4 years ago and the price has increase at least 50% today. The design works in a way that it cuts very clean and there is little to no stress marks. The single blade design motion is similar to you cutting a plastic with hobby knife. Stress marks happen when the plastic is pulled when two blade is crushing the plastic (more so if the blade has been used for some time).

I rather spend that much (actually, a fraction of that) money on really sharp blades and quality filer.

For me the issue is less about the $$ and more about the time. I have limited time to build a kit due to kids and wife. So God Hand really save a lot of time.
My process now is : Cut far away at the runner using cheap plamo cutter -> cut flush against part using godhand -> minor sanding if needed (usually no need).
Build time become less and I can build my favorite kits even when only having 1 to 2 hrs a week to build.
Obviously if budget is an issue or time is not an issue then using the knife/sanding method also works.

Do's and don't on using Godhand. Never ever ever cut the runner using GH. You'll break the fragile blade of the nipper.
Also don't drop it and if possible keep it with the cover over the blade when not using. I dropped my first pair and the tip broke.

This post has been edited by mrg220t: Sep 27 2017, 09:37 PM

Psycho Zaki done!

This post has been edited by TheEvilMan: Sep 27 2017, 10:59 PM


Attached thumbnail(s)

same here bro..i have over 50kits backlog, no time at all

Guys, can I check with you all... About the PG Unicorn (Green Color) Edition, is it limited edition version? Do I need to make preorder to get this unit?

local gunpla event last Sunday

not many participants... chances to win RG G3 gundam is very high



This post has been edited by ralph_d: Sep 28 2017, 10:06 AM

It's web exclusive but u can find it in some local hobby shop for a hefty price

If I get it in Tokyo, will it be somehow common to get it? This model looks nice, especially the shield