Guys,

Need a favor. I have an USG connected to a POE switch & a cloud key. I try multiple times to get it to work but didnt happen.

On the setup page, choose dhcp also doesnt work, pppoe also doesnt work.

Anybody can point me to the right direction? My data is bad at home so unable to scroll thru all prev pages here to study.

Tq2

Thx for the prompt reply bro. Anyhow, my setup just now on the gateway setup screen, i chose PPPOE option, key in Unifi id & password. Save, then nada. Nothing. Error or something.

Connection was TM BTU > USG. Tested via dhcp by using the TM Router > USG. Also doesnt go to internet to proceed setup.

I did read this earlier yesterday but unfortunately during the setup page only show this page:



So tried DHCP - Nada
Tried PPPOE - No option for VLAN tagging.

Hence the headace. Apologize - Newb in networking.


Appreciate the video bro, I'm gonna try this out next week as I can't configure the network on Thursday - Saturday.

------

Another question, since all the AP's is installed on the ceiling, & on the switch I saw it shows as "AP managed by others" - Is there any way that I can adopt it directly via GUI? Or do I need to reset it first?

Thanks thanks thanks

I didn't check yesterday but I saw a FAQ on UBNT page that the POE injector have a reset button on the bottom to reset the AP; I'm gonna try that rather than climbing up the ladder to reset all the AP deployed.

Got it. I'll be back with more question

Guys,

Need some insight as I'm a real newbie in networking.

Anyhow, I bought 1 UBNT POE Switch and 3 unit of AP's to replace my workplace old Cisco AP. At the moment, the current config is:

Fortigate > Cisco POE Switch > AP

On the Cisco POE Switch, I saw VLAN 1 is for office network and VLAN 2 is for guest network; how do I do the same on UBNT switch?

Thank you so much. Hope get some insight from here.

It's US Switch.

Now my config is:

https://imgur.com/a/wGP3Jpj

Can't get any IP

There's a second picture in the link boss. Do review it please.

That's it for the switch?

Means I need to configure the port on Fortigate to sent the VLAN over to the switch?

Now the fortigate port 7 is configure for Guest Access. So let say I want to use port 8 on fortigate, I need to config the port the same as port 7 in order to have VLAN 2 working on the swith?

Apologize, I'm damn confuse also on my question hahaha.

Does basic "Guest Isolation" setting on the UniFi switch good enough?

Boss, would it be possible for me to PM u my current config on Fortigate & UniFi Switch and could you point me to the right direction? As I'm scratching up till I can see bold spot already.

If it's not too inconvenience for you.

Appreciate it boss.