Flash directly, refer here Link

May i know which tomato firmware version you flashed?
Doesn’t seem like it’s been updated in a while

Hi, may i how you did it?
I tried uploading the freshtomato from xwrt but i just bricks the router. Had to go back to cfe method

So i’ve been stuck almost 1 hour trying to boot to cfe page. Had no issues last time, but this time repeatedly pressing power + reset button 15-20 sec just doesn’t bring that page anymore.
Any ideas guys?

Had to reset nvram then i was able to access cfe properly
Btw, on freshtomato, how to setup as wireless repeater?
Basically like this

4g usb modem —> freshtomato ws880

On wxrt there’s a repeater option for that, which makes it easy to setup.

I also noticed on xwrt, if i try to set 4g modem as WAN
I get really slow download speed (0.5mbps) but high upload speed 🤔

Hi guys, how do you configure pppoe settings to connect unifi?
I already key in username (@unifi) and password but it’s still unsuccessful to connect

You need set vlan tagging settings for unifi also. This is located in LAN - > IPTV.
Choose Unifi profile or manually set it.

How do you even reach that daily use 😅

Thermal pad gone...

Also had two WS880. Given up after almost daily hang. Refused to buy thermal pad and I just used a lot of thermal paste and it was good for few months then start to hang again. Change to Tenda AC18 and it boosted my parents house Unifi speed. I already cracked open the case and install a fan to cool it but still hang.