eerrr, bout that, i'm sori, wrong info, already checked it, actually they wasn't selling the colored clear type, but they tinted it again sori for the wrong info

This post has been edited by E-J@1: Jan 3 2007, 05:02 PM

Nice work...you truely have all the talent there

actually the new arcylic is prepare for other casemod la, no choice now so use it here lo. the tinted one pasang to other casemod....





actually i know to tint arcylic also, hahahaa........





hahahaa, thank you my best frend...... when u wan to start mod ya case? holiday come my house mod together ok!!!





thanks

I have the totally same casing as you for quite a while already.
Always wanted to mod it but didn't dare haha... I guess I'll just keep it this way.

Btw, incredible work there. Mind doing it for me as well?

haha. pm me la...

i got 1 question la!

i am planing wan to cut a 12cm blow hole, which part will more better to pasang a 12cm fan on my case???

up o side panel? any suggestion, thanks.....

I think up is better. Because the fan will obstruct the view to your pc's internal if you put it at the side.

give some suggestion please?

wanna ask sumthing to mod ur own casing at least how much to spend on the tools to mod ?

jay.. if u blow 12cm at side panel.. the fan later will block the view of ur mobo lor.. my opinion u better blow up there? i mean on top case =D

I suggest you cut a 120mm hole from the top to suck the air out.. maybe two holes. Then cut two more holes from the bottom where it will blow the air in. That's what i'm doing to my mod.. although still haven't updated it. I can show you once i've done it lar.. ok. Don't do on the side unless you don't mind that ppl can't really enjoy the view of the inside when a 120mm fan is blocking the way. Keep ot up mates... cool mod.

yup, i also think like that... the problem is i have to take out all the hardware again if wan cut at the top... tire...





??? what do u meanse?





ok ok, good... thanks ya suggestion!





faster update la, wana see ya casemod loo...

let say i make a 120mm blow hole at the top & one 120mm also at the front panel, but both is suck the air in... another 2 80mm fan at the rear panel is for out de ok ma? cos i pasang 2 fan at my rear panel already....

why not blow hole it both? can't fit ka? if that the case, better blow hole it on top, cause can exhaust heat accumulate there, ur heat will trap there but not totally trap, eventually it will get out slowly

i wouldn't recommend u to blow hole on the side panel cause u already got 2 fan exhaust the heat from the rear which is the rear fan + the psu fan, i think it will be enough for the 2 fan to exhaust the heat...

That's just my opinion, in the end it's up to u to decide it... just don't blame me if the temp didn't drop, i giving my opinion based on my experience from my "Black Parade" case mod by Ianho cause it''s hard to compare two different cases with the same amount of intake/exhaust fan as it depends on what ur hardware u using (how much heat produce by ur system), the cable management (which can obstruct the air flow) & lots more

haha, i sure will not blame u la .... just will appreciate ya opinion lo

wahhh... ya black parade very nice lo

i decided to cut a 120mm blow hole at the top part tomorro no working so will do it tomorro... haha, got update tomorro!

can't wait for it

hope today got time la....

i mean the tools that mod the casing .... the tools that needed to mod is how much ?

cos i have complete set of tools already so no need worry the cost of the tools now....

screw & tight the arcylic with side panel....









This post has been edited by j@y !!!: Jan 11 2007, 05:07 PM