I just watched it. Hella long and very detailed! Hopefully they can tweak the firmware to allow use of the more easily-available 316L SS, and bump it down a notch for Ti. If not, we'll have to fire at lower temps to compensate. This mod's my carry-around one and I only use it in power mode while outside. I'm itching to try stainless steel, but 304 may be not that easy to find! I think the ipv3 li will work well for your purposes, and if I recall correctly, it's firmware can be upgraded. That's a very important thing in a regulated mod (at least to me). No point getting locked into a dead end.

guys, shopee's joenida, crown ori can trust?? too damn cheap causing me to suspect leh...

so much poison this week
Ipv D3 la,
xcube mini coming this week, wonder how much it's gonna cost?

already got shop sell xcube mini.. price around rm220

Hi all,
Newbie here, i m planing bought a tfv4 mini but got few question here.. can i use normal kanthal on tfv4 fire up to 70watt? I saw a lot feedback tfv4 mini top filling will leaking cause of the white rubber lips hole cover. Tfv4 or Tfv4 mini the best choice?

so fast? which shop selling adi?
with or without battery?

guys, shopee's joenida, crown ori can trust?? too damn cheap causing me to suspect leh...

yeah judgement pending 

err i mean the jury's still out

are you sure it isn't just dry hits since it's only after a few puffs :?

just received my shipment from Joenida of Tfv4  and Uwell Crown
both Original , through website verification
http://www.smoktech.com/support
http://www.uwell.cc/fwcx.asp
buy with confidence!!!

Yup sure.
Recoiled.Better now. Yes because the juice dried. That i know. But wondering the metal vape/fumes. How dangerous is it.
Oh well nevermind.

Btw since i havent stop reading joenida for the past few days and weeks maybe. What good to buy. What was that code again?
And the mod. With TC you say? I never owned a TC before. So can someone pls point me the link before promo is over.

Thanks guys.

Yup sure.
Recoiled.Better now. Yes because the juice dried. That i know. But wondering the metal vape/fumes. How dangerous is it.
Oh well nevermind.

Btw since i havent stop reading joenida for the past few days and weeks maybe. What good to buy. What was that code again?
And the mod. With TC you say? I never owned a TC before. So can someone pls point me the link before promo is over.

Thanks guys.

Just like quite a lot of our local backyard brewers - the labels says 6 mg but in reality they only use 2 to 4 mg.

Not saying that your supplier is cheating you, but there are some un-scrupulous guys who dilute their nic by more than 25 percent lower.  If you are a serious home brewer, you should test the nic you bought to make sure the labeling is correct.  Google for diy nic strength test kit.

It could also be you made a mistake while keying in your ingredients into the online eliquid calculator.  You may consider cross checking by using manual calculation as follows:

Objective : to brew 30 ml juice with 6 mg nic using 48 mg strength nic base

amount of nicotine required will be 30 x 6 = 180 mg of nic

amount of nic base at 48 mg strength = 180/48 = 3.75 ml of nic base

By substituting the parameters, you can ensure that there are no mistakes made in your recipe.
But wait!!!   

Did you mix all ingredients thoroughly?
Did you steep the brew?  I don't think you did - you just test vape it immediately after mixing....

The lack of steeping may account for the lack of throat hit as the ingredients had not been steep properly.

Yep, could be. Anyway gonna steep them now for a week. However, i don't think my 0mg (nic) recipe will have any throat hit though.

lol no need for attitude, you mentioned that you get "burnt metal vape" after a few hits. so it could just be dry hits. dry hits in general is bad since you're burning cotton instead of juice that's saturated within the cotton hence releasing formaldehyde.

as for how safe inhaling something that blatantly tastes janky, I personally wouldn't.

Joenida http://mall.shopee.com.my/shop/?sid=843625...h#shopid=843625 : i think promos over but try

alexng
http://mall.shopee.com.my/shop/?sid=682732...t#shopid=682732

look for vtc mini or ipv d2 for cheap tc mods

all the best!

but wait.. something's not right.. prices are now not that cheap anymore 

Yea i did get that. Think i was burning it too high too fast. Well still a noob here. 3.4v 0.6ohm should be ok right?
Wasnt giving any attitude btw. Well maybe a littal.
DANG IT! Took me a while to be bought, once bought the promos over. GREAT, just great.