So yesterday I bought a Rose Gold and Gold, under certain lighting condition they do look quite similar.

Not everything has 3D Touch support now and also you can set the sensitivity (less or more pressure) of the 3D Touch under Accessibility settings.

But better you check with Machines if you can take an EPP for iPhone as I know some Apple resellers have EPP but not for iPhone.

I think both OS are good but I feel Android is much suited for those who really take advantage of the flexibility of it and most must go through the rooting process.

iOS may seem like a very restricted system but as the old saying goes, "it just works".

Try updating at wee hours, yesterday I reached home about 3.30am and all the app updates were blazing fast. Just now when installing new apps, the speed is kinda crawling again.

Yea, I think telcos and Apple resellers had overestimated the demand this time.

Same here, and I'm using Nillkin tempered glass.

Just curious, when I was with Maxis it will show LTE whereas on Celcom it shows 4G, anyone know specifically why is that so?

When in low power mode, is there any way to allow certain apps to still have background refresh and notification? I'd still like to have my messaging apps to come through as when I'm on low power mode, I have been missing out on messages.

Yes it's like that for now, so better not buy expensive ones first. I've went through few tempered glass which are really cheap and all have the same problem as the expensive ones so it's more to the glass curve in the 6s.

Yea should be because the messages only come in when I open the app so I believe apps are not allowed of any background activity as well in low power mode.

I think the film ones should be slightly better since they tend to be more flexible, even if it does not stick properly it should still be less obvious than a tempered glass.

I've tried tempered glass from Nillkin, Remax and Loca, all show the same issue at the edge of the display which is probably where the glass starts to curve. However, it is still acceptable to me so I'll continue using it until a company releases a tempered glass which is 100% compatible with the 6s, it is now only 95% compatible in my opinion.

As far as I know, many have mentioned that as long as the glass is not thicker than 0.3mm it should work. All the tempered glass I tried is 0.3mm and have no issues with 3D Touch.

Yea, Background App Refresh is on. I'll try to reinstall the app and see.

It's a new phone right? Wait a while and see if it improves, some say that this kind of issue is due to some sort of glue inside the display that have not fully cured and will go over with time/use but I'm not too sure how true this is.

This post has been edited by OKLY: Oct 17 2015, 11:09 PM

Does the 6s have lower cellular reception? I used to be able to get strong 4G signal with my previous phone but now the signal is too low on the 6s that it is connecting to 3G only. Same experience in my house where previously it is full bar 4G but now it is about half only.

Same as nemesis94, coming from an Android phone.

I'm using a Spigen Case Capsule but I don't think it's that thick.

So much water from the baby wipes? I guess the baby wipes got compressed/squished.

Why is it so difficult to get AirDrop to work? Both 6s can't seem to find each other even when AirDrop is selected to show everyone.

Must both device/phone be connected to the same WiFi? It should work without being connected to the same WiFi network right as sometimes we don't have a WiFi network to connect to?

It is on, just not connected to any WiFi network.