OMG! not a smoker but start to vape. for me its fine. pretend like shisha la but in healthier way lol

maybe its your coil. try check your coil and the screws. tighten it. try and error. definitely your coil.

dont kacau your MOD.

not kacau..btw thx bro..coz last time mine is ipvmini..then my cousin send to his friend change to ipvm2..i was like wtf?

if the ohm keep changing like that the taste is bad...

Check your coil, make sure all screw is tight.

hey guys.... so i wanna ask have anybody here try juice machine before???

can recommend flavour that is sweet or creamy as the above flavour mention??? thx

Clean your tank including the screw area. Then recoil. Should fix the problem.

Hi all sifu. Wanna ask about watt amp resistance relationship.
Was vapin on 0.5sub ohm at 20-22 watt nice vapor and no burnt taste
Tried 1.5ohm. Same wattage will get burnt taste. Why?
I tot higher ohm mean less heat. So I expect 1.5ohm joules fire higher than 22w?

http://vapecalc.com

Use this calculator to get Amp. Higher amp mean dangerous for battery rite? 1.5 ohm 20wat only draw 3.65amp where 0.5 ohm draw 6.33amp.

Higher amp higher temp no? But in my case terbalik

Lower ohm higher watt, higher ohm lower watt..

Higher watt= more heat rite?
1.5ohm and 0.5ohm. Why 0.5 ohm can take higher watt
0.5ohm less resistance mean heat up more than 1.5ohm rite

any sifu willing to share DIY recipe to make juice taste similar to Paddle Pop flavour? hmm

I should try fcukin flava all cloud. Got Ribena and Honeydew.
Check my siggy.

Simplified like this.

Higher resistance - Lower wattage. (Keep it below 4.2v) = This for flavor mode


Lower resistance - Higher wattage



So if you exceed 4.2v on high resistance. Chances of getting dry hit/ burn cotton is very high.

If you use low wattage on low resistance, you get less vapor (macam less power to drive)

Yes but you forgot 0.5ohm to heat up is slower because less resistance.
1.5ohm heat up super fast due to more resistance.

Example:
fire 1 sec 20w
0.5ohm - not enough vapor/flavor
1.5ohm - good vapor/flavor
fire 2 sec 20w
0.5ohm - more vapor/flavor but not enough
1.5ohm - got vapor/flavour but a bit burn
fire 3 sec 20w
0.5ohm - good vapor/flavor
1.5ohm - burn/dry



This post has been edited by sett: Aug 7 2015, 04:33 PM

everybody off today and drunk already ?

obviously depends on coil/wick/tank setup and not forgetting mod/battery limitations

i guess so, nothing better to do

the replies earlier is correct..

another analogy u can consider is rope and string..

a rope is thicker than a string, if u soak one end in a water, obviously the string will absorb the water faster than the rope..

dont ask what material as each material soaks liquid differently.

so does heat.. burning a string from 1 end to another is faster than burning a rope..

most sub ohm coils are built on thicker wires, 26gauge and below...

coils 1.5ohm are built using thinner wire, 30gauge and above..

thinner wires heat faster than thicker wire, hence u need lower power to get glow fast, between 12watt to 15watt max.. more than 15watts, burnt taste already..

thicker wires need more power to heat up, 18watts and above..

Haih.. Wanna order stuff from FT also need to think twice now since ringgit so weak... Keep falling day by day...

Selling brand new iPV4S silver colour for only rm280. Pm me if interested. Thanks

hi guys wanna ask any tank good with ipv d2 ?

Hi fellas,

A friend of mine just started his vaping business. It would be great we get some support from you guys!

Here is the Facebook link; https://www.facebook.com/groups/287490631419860/

P/s: We're new. Your opinions would be very much appreciated!