Screw the occ tight enough should be ok. Try to dissemble the whole tank n soak in warm water. Then assemble back n see. I've been using herakles for almost 1 month, no major leaking issue except slight leaking from air hole due to vacuum

Burnt taste? He's using the 0.2 or 0.6 occ? What's the wattage he's been firing? Is he using the original occ?

This post has been edited by cyapd: May 28 2015, 04:16 PM

Hand twisted or drill?

If drill, i usually keep going till one end snaps off then sambung lagi go again till it snaps again. Then you get really tight twists like this.

okay will try. thanks yo

hand twisted ,i dont have a drill but can i ask the danger of vaper this kind of wire

btw so nice the wire

This post has been edited by Domomo: May 28 2015, 04:18 PM

Hi guys anyone wanna buy my Eleaf Istick 30w with Nautilus mini?

Bro, bring the wattage higher. 2.4V might as well don't vape...hehe. Bring it up to about 3.5V. Looks like you are using the 0.5ohm OCC which means upward of 20 watts.

This wire is a twisted 28 Ga, if you wrap it around a 2.5mm bit 7 times it comes out at 1.12 Ohms

The danger is if you start vaping beyond the battery amp limit.

cant u explain it abit blur about the battery

Do you mind to explain a little bit more about sub ohmer? newbie here haha

im oso nubis

ppl who vape under 1ohm.. am i korek?

Don't twist too tight. Defeats the purpose of twisted. It's supposed to leave pockets for juice to pool. I used to twist till it snaps off. Then I tried looser twists. Prefer looser twists.

This post has been edited by JimL: May 28 2015, 05:16 PM

https://www.facebook.com/vapekulture/photos...0862853/?type=1

i have 2 x 18490 and a 18350(just because it looks cute) lol but 2 x 18490 can last me up to 2 days unless i chain vape.

Subohm normally means the resistance on your wire is lower than 1(usually around 0.2 - 0.5 as per today's standard) and per calculation you need to fire your device on a minimum of 25w and above. This will result in massive clouds of vapor.

The provari does not support anything lower than a 0.5(latest version 38 update) and it can only fire 20w. so if you want a provari, you can count on it to be working perfectly everytime you screw a tank onto it.
I'm currently using a dripper with dual coil 28ga 8 wraps 0.6ohm on my provari and i notice the heating is slower than you pumping 40w, but when the coils heats up, it can deliver results.

hope you understand

Any pipesauce fans? We are having a giveaway!

https://www.facebook.com/v4p3dotcom/photos/...?type=1&theater

give me pls ..

any one know where to get ipv4 rm260? my fren show a pamphlet he found at facebook, but dont know the shop name or the location T_T

Dunno where but recently there was a group buy on here that managed to get it for RM255

Hey guys, I'm really new with vaping.

Budget wise will go for around rm300 and below.

So where should I start? Hope you guys can shed some light.

Cheers!