QUOTE(Bazinga! @ Jun 22 2015, 11:36 PM)
Today diy spray front grille matte black
Gr8 job there!
Well done!!
PROTON SAGA BLM, FL & FLX Thread V67, U haz CVT Falcon PUNCH liao?
|
|
 Jun 23 2015, 11:29 AM
Return to original view | Post
#41
|
 
Senior Member
784 posts Joined: Jan 2003 From: Rice Bowl of Msia  
|
Today diy spray front grille matte black Gr8 job there! Well done!! |
Quote|
|
|
|
|
Jun 23 2015, 01:01 PM
Return to original view | Post
#42
|
|
Senior Member
784 posts Joined: Jan 2003 From: Rice Bowl of Msia
|
Hi Everyone!
 Juz2share... Modified DIY OCT now with Oil Drain Screw...  » Click to show Spoiler - click again to hide... « This post has been edited by zeone: Jun 23 2015, 01:04 PM |
|
|
Jun 23 2015, 08:31 PM
Return to original view | Post
#43
|
|
Senior Member
784 posts Joined: Jan 2003 From: Rice Bowl of Msia
|
QUOTE(athrunzaru @ Jun 23 2015, 05:55 PM) the weirdest thing is my DIY OCT not much oil captured inside, why? Hi Bro... Firstly, how much EO do yu expect 2b collected? In my case, only abt 3-4 ml was collected in that "fuel filter OCT" over abt 5Km use...mostly city/town driving...  Secondly...To which "outlet" did yu connect tube to the OCT? Facing the car, it shld b the LHS outlet tube @Rocker Cover... ie inbetween PCV tube to inlet manifold... NB. Officially..that's the RHS... Haha!  IINM the other tube is supposedly for air intake juz b4 throttle body to provide clean filtered air into Rocker Cover...  However if yu do alot of hi thottle openings (hi revving), then there's possibility of EO fumes being sucked by greater vacuum @ that "air intake" tubing... To prevent that, yu can use a small sp air filter (PCV filter) unit 2connect as an Independent air intake filter. Then it wld not b affected by yr throttle openings... This post has been edited by zeone: Jun 23 2015, 08:47 PM |
|
|
Jun 23 2015, 09:43 PM
Return to original view | Post
#44
|
|
Senior Member
784 posts Joined: Jan 2003 From: Rice Bowl of Msia
|
QUOTE(athrunzaru @ Jun 23 2015, 09:24 PM) i expect it to be a bit more, but it does it job, like a few drips been captured. yep i connect it between the intake hose and the rocker cover (the right part facing the engine), another one at the rocker cover to the...bottom of the intake manifold i guess (the left part)? Hi Bro... i change it out every oil change Good4yu...doing 4both... ps. My latest DIY OCT mod is 2b able 2juz drain out the collected condensed EO...juz like in REAL OCTs...  This post has been edited by zeone: Jun 23 2015, 09:46 PM |
|
|
Jun 28 2015, 11:09 PM
Return to original view | Post
#45
|
|
Senior Member
784 posts Joined: Jan 2003 From: Rice Bowl of Msia
|
QUOTE(davidke20 @ Jun 28 2015, 10:09 AM) Mine, 1 is 2032, another 1 is 2x2016 Hi Bro YAB...  The 2032 remote fob can sen signal very far. However, the 2x2016 is not too far, but it can penetrate multiple concrete wall and still able to pass signal back to the car Hi Everyone! All doing well & fine...I hope...  Re batt 4remote, can a pc of 2032 fit with good contacts in the batt3 holder? Also is the Remote circuitry designed to accept a higher output current? Since the holder is originally designed for 2 pcs of 2016? In view of abv, wld replacing 1pc 2032 for the 2pcs 2016 provide worthwhile benefits? Tqvm in adv. ps. Btw both mine came with 2x2016...hv replaced both once... |
|
|
Jun 29 2015, 05:38 PM
Return to original view | Post
#46
|
|
Senior Member
784 posts Joined: Jan 2003 From: Rice Bowl of Msia
|
QUOTE(wankel @ Jun 29 2015, 08:50 AM) A can of worms has been opened. Hi Bro... After reading the posts here I changed my CR-2032 for two CR-2016 (which was rather a chore because the first pack I grabbed was old and stale and only pushed out 0.2 V each, but they were 9 years past BB date) then a newer pack had one out of the first three slightly low, only 2.88 V) and the result is the LED lighting now as its threshold must now be exceeded, and the range vastly extended. Slightly too early to endorse fully yet but more feedback may suggest all owners check and change to 2 x CR-2016 if no drama occurs. Re abv...me chk-ed 2b very sure... Both 2032 & 2016 are rated as being of 3V... So using 2x2016 in series is equivalent to total of 6V supply. That wld mean 2X the previous operating voltage of Remote fob... ie if remote fob was originally fitted with only ONE 2032... And it wld cause functional probs if circuitry originally meant/set up for ONLY 3V !!   ( If my memory of basic electricity not fail me...  )As in response by Bro YAB davidke20, me too wld NOT dare 2try... Esp now with abv info & knowledge..the electronics gonna b "fried"!!  However, if one were 2replace the 2x2016 with 2x2032, kinda feel the change might work... Since the total voltage is still the same...6V. Only prob is wld 2x2032 fit in2 the same holder...? Thickness? This post has been edited by zeone: Jun 29 2015, 05:49 PM Attached thumbnail(s) 
|
|
|
|
|
|
Jun 30 2015, 11:44 AM
Return to original view | Post
#47
|
|
Senior Member
784 posts Joined: Jan 2003 From: Rice Bowl of Msia
|
QUOTE(wankel @ Jun 30 2015, 04:31 AM) I did a bit of checking out my remote Hi Bro... [attachmentid=4516497] The HCS300 is the workhorse and its specs show its Voltage limits between 0.3 and 6.6 Volt but it also shows current drain is much higher at the two cell level than the one cell variant, this would tally up with the noted extra range experienced, but of course the downside will be a much reduced battery life. In my case the shorter battery life may enable to use my house stock before they die from old age. Anyway I'll continue with my experiment until it fails or I hear from another failure. The silver EPCOS chip I believe is a filter and with a 1 meg resistor to it I doubt any stress will be caused to it. Fyi me hv juz replaced the 2x2016 in my mainly used remote fob... From Energiser make to China made ones fr local MrDIY stores... Lots cheaper but hopefully reliability is not proportionately worse lo... My used Energiser were juz abv 3V each..and the new ones @3.4V each. Tested. Range of operation has increased noticeably!! The question now is...for HOW LONG...? NB. Nowadays practically EVERYTHING seems 2b Made in China... This post has been edited by zeone: Jun 30 2015, 11:48 AM |
|
|
Jun 30 2015, 05:20 PM
Return to original view | Post
#48
|
|
Senior Member
784 posts Joined: Jan 2003 From: Rice Bowl of Msia
|
QUOTE(dagreatdzul @ Jun 30 2015, 12:52 PM) my key from 2009 still ok the battery. just recently weak, but still can use =) Hi Bro... Fyi my remote fob was still working fine...except me felt it shld be possible to work at a greater distance... On chking, the voltage of each of the 2x2016 cells was kinda juz slightly abv the 3V mark... IINM all new batt3 in good working condition, are at a higher value than its rated voltage... So felt replacements (since me hv spares handy) wld give the remote better functionality coupled with peace of mind for me... This post has been edited by zeone: Jun 30 2015, 05:21 PM |
|
|
Jul 1 2015, 03:50 PM
Return to original view | Post
#49
|
|
Senior Member
784 posts Joined: Jan 2003 From: Rice Bowl of Msia
|
QUOTE(dagreatdzul @ Jun 30 2015, 12:52 PM) my key from 2009 still ok the battery. just recently weak, but still can use =) QUOTE(iskazulka @ Jul 1 2015, 08:00 AM) probably fake. lol. Hi Everyone! Bro dageeatdzul ... Wow! 6 years! That's fantastic!! Congratz!  QUOTE(TitanRev @ Jul 1 2015, 09:02 AM) No problem with my key fob. Actually mine also no prob... Was the second change this time arnd... Cld hv continued using the remote but... Since oledi opened up, tested below par & with spares arnd...me thot might as well replace with new batt3 lo! Cost was like only RM3.50 for 5 pcs? This post has been edited by zeone: Jul 1 2015, 03:58 PM |
|
|
Jul 2 2015, 11:11 AM
Return to original view | Post
#50
|
|
Senior Member
784 posts Joined: Jan 2003 From: Rice Bowl of Msia
|
QUOTE(r_5th19 @ Jul 1 2015, 05:26 PM) me also almost 6 years and just recently week. replace it with 2x2016 cells from MrDiy. Hi Bro... from far can lock/unclock now. Mayb me shld put back ole batt3 set juz taken out few days ago... Mayb can get another 4 years fr them? ps. Wld need 2carry spare remote arnd...juz in case! Dun wan 2b stranded la... |
|
|
Jul 2 2015, 11:13 AM
Return to original view | Post
#51
|
|
Senior Member
784 posts Joined: Jan 2003 From: Rice Bowl of Msia
|
Hi Everyone!
Post #2502 liao... |
|
Topic ClosedOptions
|
| Change to: |  0.0209sec
 0.54
 7 queries
 GZIP Disabled
Time is now: 11th December 2025 - 10:38 AM |
All Rights Reserved © 2002- 2025 Vijandren Ramadass (~unite against racism~)
Powered by Invision Power Board © 2025 IPS, Inc.