noobandroidHHKB Disassembly Guide
Step 1: Loosen and remove the 3 screws at the back of HHKB. You can easily see 3 screws holes.
» Click to show Spoiler - click again to hide... «
Step 2: Remove the back casing carefully, there is a controller at the back of the casing. I use a small glass bottle to hold the back casing.
Remove the screws on the pcb. The screws are highlighted in white circle.
» Click to show Spoiler - click again to hide... «
Step 3: After remove the screws on pcb, close the back casing. Then flip the HHKB to the front like in the picture.
So, the domes will not fall out.
» Click to show Spoiler - click again to hide... «
Step 4: Remove the top casing.
» Click to show Spoiler - click again to hide... «
Step 5: Flip the top casing and put it down.
» Click to show Spoiler - click again to hide... «
Then, you can start inspect why your board got ants.
This post has been edited by quovadis123: Dec 12 2014, 10:10 PM