I've seen before, Grey is for White parts. Brown is for Red or Yellow parts. Black is for Blue and Grey parts. Although since I was a beginner to panel lining, I only bought the black marker and used it on my entire Astray Red Frame PG. Doesn't look too bad. But will try the other markers in the future.

The Gouf I bought during last warehouse, don't know why I finished this kit first, my PG 00 Raiser has been in WIP for two years

Goint to repaint the back of the shield, I thought it wouldn't be noticeable, but it was.

Nu vs. Sazabi

which type of gundam marker pen u used?GM-??

I'm using GM01.

ok thk...just now go time square only able find 1 shop(gamerarena) but he left Gm01. I should buy it instead of waiting GM02(out of stock).

I suggest you get all three for variety and to experiment xD.... From what i observe, using black for most kits turns out pretty nicely =)

Guys what suitable time to do topcoat because i hear that for topcoat work should be done in the morning

ok man,will try go n buy a black color tmr to trying!!! XD. When grey color got stock then use for my second gundam

There's 2 shops in the IT mall in Time Square actually.

U means the IT mall is that the place sell sell camera/computer? the ground floor or 1st floor one?

Yes. Time Machine and another shop is there too. Right at the innermost corner.

Gamers Arena - 7th Floor
IT Toys - 2nd Floor (inside IT Center)
Time Machine - 2nd Floor (inside IT Center)

NO, not morning! Not when its cold!
Find a time that the sun is right on top on your head, and its so hot you have to wear a singlet. That is the most suitable time for top coating!

NEVER TOP COAT AFTER RAIN, NEVER TOP COAT WHEN THE WEATHER IS COLD. NEVER.

Always topcoat under direct sunlight in the afternoon, around 11am to 4pm. 12pm-2pm should be the best

yeah...thank.Just check with Time Machine they say have all stock of pen

Tq.. Is it have any different timing for glossy and matte?? Or all type of top coat can be done between 12 - 2??

No difference, but you should take precaution. Always allow 20-30 minutes of the first layer to completely dry, otherwise when you spray the second layer of coating, frosting can still occur.

if using top coat for hobby, its quite easy to use..
dont forget to cover/mask clear parts/metallic parts that you dont want to be covered with top coat..

I am going out of my mind!!! I can't believe i am financially tight now >.<

Turn X (MG) for only RM150~~ Anyone would want to grab it?