icic.. do u know anyone selling here in lyn? btw 1cm thickness too think?? wat measurement consider thick? and wat thickness is necessary?

1cm isn't too thick ... as long as u have the clearance to apply it, then it's fine //
However take consideration where u want apply the foam .. coz side panel usually have very small clearance so 1cm foam might not fit well ..

the thick foam could be used at the bottom or top of the case as well as the rom cage to absorb vibration.

most of the links are dead

wow u are excellent..i agree with pin tis up, nice work dude, good luck

headache, my new comp doesnt come with any molex, now i wanna add a new fan and there is no power source.

there is only 4pin floppy connector:



can i cut out the 4pin floppy connector and join the molex like this? i dont know how to take apart the molex, if it can be done that is even better.



thank you for any help.

You have to check the voltage needed at the terminals whether they correspond to the exixting ones, otherwise you might spoil the PSU or the divice and might be uneconomical to repair.

thanks, i dunno how to check at the terminal, the cable goes into dvd rom drive first, then to floppy connector, both from the same source, is the voltage ok?

u can check back with other psu dat hv molex..check the wire color b4 u join ur new molex to floppy wire i think np..jus make sure the wire color in correct position..if not ur hardware will burn out

wire color no problem already, found info from website.

i only worry about the way i cut and join.


Attached thumbnail(s)

i've done sum b4 using wire connector ..its work..but dunno in long term running..i think if jus place one molex wont harm it..u use wat to join the wire?wire connector or tape?

so you tried it before it worked!! thats great.

i plan to use a wire connector, the normal used for electricity wiring one.

for the wire, you use what to cut the outer rubber? i need to buy one for this smaller wire type, dunno which cutter can do it.

yeah..it work..i used normal cutter last time..the molex u can cut from faulty psu..haha i did it last time..no need to buy wire n molex..cut molex wire from psu n join it wit ur floppy wire ..if u looking for great looking can also solder it.then tape it.sleeve all the cable

thanks, i will start the project soon.

Folks,

WTA, how to paint these fan grills, iinm if just spray paint it wont last n the paint will flak.....sandpaper or primer maybe


TIA

Yah, for any paint job, sanding and applying primer is a must practice to ensure the longevity of the paint...

So u gonna paint it black ? hehhe I bet u are busy with ur new big boy now ..

can't wait to see the results ...

so sanding as in sand off the stainless steel, then add primer?

yah .. just sand till surface is a bit rough so that primer could stay strong on it afterward ...

wookay thx will try

do anyone know how to make your cpu casing glossy look-like? from flat black colour?

This post has been edited by m2n-e: Dec 5 2007, 08:33 PM

just spray a few layers of black.....