this is y cable




Attached thumbnail(s)

think can use the gun glue..if not mistaken ian using it on my mesh slot front cover..

mite b he wanna noe urs its true power psu or chapalang one..since u u splitt for more molex mite cz ur psu didnt stable if using chapalang unit wi lot of hardwares..dats wat i wonder wat he tryin to figure out

yeah..u can said lidat..but even urs is 400w..its serve u not 400w..mite b around 2++w..its depend on wat hardware u using oso not jus the quantities..e.g high end gfx need more power, same as few other hardware.. but u can try..hehe its jus the caution dat mite happen if its underpower then mite blown ur psu n other stuffs

This post has been edited by mfcm: Apr 3 2007, 03:27 AM

u can try refer to others worklog or mayb from allngap since he's such good led part..same goes to bombman

u can check back with other psu dat hv molex..check the wire color b4 u join ur new molex to floppy wire i think np..jus make sure the wire color in correct position..if not ur hardware will burn out

i've done sum b4 using wire connector ..its work..but dunno in long term running..i think if jus place one molex wont harm it..u use wat to join the wire?wire connector or tape?

yeah..it work..i used normal cutter last time..the molex u can cut from faulty psu..haha i did it last time..no need to buy wire n molex..cut molex wire from psu n join it wit ur floppy wire ..if u looking for great looking can also solder it.then tape it.sleeve all the cable

haha me form perak oso last time go down to jln pasar..not just the arcylic selling there,can got many diy stuff like eletronics part

can use bolt n nut..but i still prefer rivet..coz hard to find small bolt to fix the hole.summo the rivet make the joint more tough

bro jus got hardware shop..buy holesaw..drill it then file back..its done easy one bro..unless u wanna cut make square design then u need to use jigsaw

can..jus make sure i take othe the other sidepanel if not afraid u over cut then hit the other sidepanel..act the sidepanel can take out..jus need to take out the rivet..u need to drill the rivet

jalan pasar u can get there..or other hardware shop..size depend on u..price depend on quality and size of holesaw

try askin jetyap..or u can buy from osea

hard to get ac ryan product here..myb due to no distro get it..so hard to get..yeah mostly if u wanna buy can try osea like i did b4..if got ppl seeling ac ryan product myb u can try like jetyap..else can help u coz didnt c any shop yet selling those ac ryan product..myb u can find in bulk section