yalor.. no money to even buy threaded screws... mana macam uncle so rich I use BOLTS lar what screws... unless really cannot jalan the idea then switch to screws

noob question here..
i m wondering..
from so many case mod here..
most ppl are using arcylic as their main material..
but the thing is..
how do people tend to stick connect 2 arcylic togather..
e.g. how those mod connect 2 ends of acrylic to made a nice corner of a casing.. ??
10q...

most commonly used item would be epoxy. can get any most hardware stores.

Ur question has also bn answered here dude : >>Link<<


how those mod connect 2 ends of acrylic to made a nice corner of a casing : measure & join perfectly...not hard after some trials

Thanks Dude !!!
You rocks!!!!

help, where to buy rubbing compound & primer?

Ace hardware at Mid Valley got? Or anywhere near Puchong,

tQ

really noob question: if I were to make my very own casing from scratch with acrylic, where would I be able to get the dimensions metrics for cutting and all? Is there like a standard or an article/white paper on this were I can follow exactly?

at last i found my thread.. 10 mods 4 moving my thread here..
neway 10 2 u guy for d help..
so tat mean i gotta get an epoxy for combining to end of acrylic..
but.. will d output of d work look bad ??

noob question here:
Where can i get a acrylic? From a pc mod shop or some where else?

From advertising board shop. Those that make signboards.

Boils down how u apply it. I recommend u practise on few pcs 1st; dat way u'll knw how epoxy settles after applied. Remember practise makes it perfect

Bom Jantan... stil got those RM70 rotary tool?

Ultimax? PM me lah

Hello, this is my first time modding a casing on my own. So don't flame me for asking stupid questions. What kind of screw is it in the picture and am i suppose to remove it. If yes then what do i use?

Its not a screw, Its a rivet. If you remove it, the rivet is destroyed n u will have to replace it with a new one. If you want to remove the panel, then u can drill the rivet out.
Just use a slightly bigger drill bit then rivet hole.

Ohh, so it's possible to remove it. Then while modding cases, are we suppose to remove it?

Depends la if u are hardworking then remove it only do your mods. If u are lazy then just carry on ur mods without removing those stuff cause removing them nids hardwork - drilling the rivets out and when finished replacing them.
IMHO if u r doing a blowhole, either take out all the hardware inside and only cut or take off the top panel

If u hav a power drill & riveter ready then why not� After all it's quite interesting doing riveting jobs

one more thing.. from d latest jaws project n sum old 1 la.. by ianho..
saw all d acrylic was "pasted" to d panel instead of screwed.. how he did tat ??
10q..

If not mistaken, ianho just use double-sided tape. Correct me if I'm wrong dude

U may also use epoxy