Mr jdm expert stated that 180 meter from china la dhy

so potong lagi bagus ka

malaysia > china

Nais bro..

too bad my phone is windows 8..

Woo... New thread version d....

Check in from the land of yogi bear

Lol tarak ngam u. U xw20 mia kaki
my 50k oci in another 2k, most prolly next 2 week or so will taruk this new stuff together with the ws2 nano thingy for testing.

This post has been edited by nicotine: Sep 1 2014, 02:38 PM

Any sifu here can help me. I think my lala clutch got problem. Is a 1.8 manual. When I press the clutch it feel very very soft. I masuk 1st gear. I release clutch, lift my foot a little bit the car can move already. Compare to yesterday is totally different. Not sure how to say. Example last time need 10cm to release, now maybe 2cm u release the car can move.. Who can help? Gear oil leak?

probably clutch pump, many cases happened. send to check earlier while still able too drive, else need to call for tow truck d.

Oh ic. Thanks. New pump lo..

Send to claim

In the US there was Clutch Master Cylinder recall.

Is the master cylinder the one causing the clutch pump to fail?

i think no torque app for win8 phone

haha ya lo.

bro if i may advise, perhaps try 1 round without ws2, only shell with pure plus; Then next OCI go with ws2 and compare the difference.

It was my bad/wrong on being too impatient/hasty and just whack the additives in like that...cannot objectively compare/feel what difference they make which is a pity.
Although the main objective is to minimize engine wear to an absolute minimum, it seems that it is either impossible to do just that, or the additives aren't helping much (if any at all)

Yeah u r rite..nvm lo

Ok. I main clutch a lot

Many kantoi the slave pump with bearing

Anything we can do to avoid failure/breakdown?

My clutch operates normal, but I notice my brake fluid level is just above the low line. Does this mean my clutch system is failing? I do a lot of hill starts in a day. Maybe stressing the pump?

Worried...Main reason I got manual was I though it is super reliable.

I worry it was over pressured and stressing all the time only

Today when driving suddenly service required alert pop out from display but its gone after restart the car. Happened 2 times. I sent my car for service already a month ago (1st service). But when check the service reminder, still got 5 month and 5900km for 2nd service. Do you guys think they forgot to reset the reminder? Normally if something wrong with engine or gearbox problem, only the check engine light with pop out, right.

hi all oltimer... wanna ask, just changed to LED taillamp now CEL appear, according to all otaiss n forums , we need to add load resistor to brake lamp (taillamp) , so i go buy 2 pcs... my Q:

1) is it correct to connect the load resistor to black n green wires? not greenwhite?
use something like dis, but 8ohm 50w


2) CEL light still appear, does it go off itself or need to clear it using obd reader android (torque) software oredi hav.
is it safe to clear it our own bros.

arigato to all

This clutch pump replacement thingie will take how long?? Must leave the car at SC for days?? I think mine also have some symptom already. Sometimes gear change got crunch sound even when clutch depressed fully.

This happens especially, situation like this : From gear 4 , full clutch, go gear 3, release half clutch to slow down the car, clutch in full again to go gear 2, then the crunch will happen.