This should be fun.Looking forward to your products.

RM155 for the 170mm version. TBH, it's not much cheaper than the XSPC photon. 

yes safe..  do not worry
only run in a few minutes in the loop
then rinse with distilled water a few minutes 

If you guys are really worried about acid damage, rinse with a neutralising agent and you'll be fine.

You can just use either a baking soda or soda bicarbonate rinse. (forgot which, someone has to go double check. LOL)

But after you rinse you have to flush with plenty of water to dissolve anything that's left over.

chrono_kairo glass reservoir is rated at 60mm inner diameter? can fit into the bitspower d5 mod top a not?

I tot all will using standard G1/4 thread so male to male fitting can solve the connection issue.

If that is the case then i think the chances very slim.
Btw, maybe you can do some product showcase for your WC items so that we will more understand the product.

Photos snapping (close shoot) or videos (like what we can found in youtube).

Sadly I'm too joining the Officially Retired Club.
So here letting go my stuff. ><
Retirement Clearance Sales.

haha still retiring bro.. all this just for fun with old wc stuff and pc part
Almighty
call the Almighty does not fit me ..
still learning n noob la.. hehe..
here some picca for loop 1..  duno with one look better.. any idea?

loop 1
pump+res>cpu>ram>rad

loop A


loop B


loop C


loop 2
pump+res>gpu>rad

picca on the way.. still work in progress for best loop line..

Anyone interested in getting stuff from http://mnpctech.com/ ?

Or perhaps anyone willing to organize a bulk?

not entirely true la bro....
doesnt effect temperature if the pump is set to high...the temp will be equal since the liquid travels inside the loop very fast..same goes if u set the pump to low...higher pump settings, higher power consume... for me, what's good about the high and low setting is to control the flow inside the loop.. longer loop with more bends, can set for higher setting, while short and direct loop can set to lower setting 

Can't must be same. 5/8 OD little big compare 1/2 OD.

So if the fitting size ID/OD must  be equivalent to the tube ID/OD? 

Non of above. Currently using stock. So I came to ask before mistakenly spend my money 

You still have your fittings?does this fittings same for acrylic tube or normal tube use?

Thanks guys, not that i got money (almost broke now) but trying to minimize my time on it...so, go for acrylic tube terus....hehe..where can i get ek coolant? Xspc too expensive..

About apes, they did not reply any of my pm..i do not know why...