Guys,

Need your help to check on your fog lamp casing for Mazda 3 skyactiv. Installed some Paint Protection film earlier today on the front part of the car.

however notice that after the installation of PPF,  the plastic casing for the fog lamp found to have some hole/gap. Is it already like that for every new car or mmg poor workmanship eh?

if so, then tomorrow maybe will complain

install insulation on your bonnet already?

Damage berapa? Saw ur k&n sticker on the air filter box @ m3c lol
Can refer to my previous post , have done that and have significant improvement, if u want cheaper alternative I have other solution.

how much $$ the K&N filter ar (include installation)?

which workshop?

Same as this one below?

http://www.lelong.com.my/k-n-air-filter-ma...7-01-Sale-I.htm

Guys,

Need your help to check on your fog lamp casing for Mazda 3 skyactiv. Installed some Paint Protection film earlier today on the front part of the car.

however notice that after the installation of PPF,  the plastic casing for the fog lamp found to have some hole/gap. Is it already like that for every new car or mmg poor workmanship eh?

if so, then tomorrow maybe will complain

no, i remain the original just in case thick fog which need yellow light...
anyway, it's useless for me so far...i didn't turn it on since day 1 i took the car.

pictures 

Not original....supplied & installed by GS Accessories. Bermaz authorised  accessories supplier..wont void warranty if install at GS. One to one replica.  Price: RM580 including workmanship. Bear in mind, during warranty period any wiring or electrical modifications done to mazda cars under Bermaz distribution if do at other accessories shop might void warranty

yesterday i try speeding...
the wind sound very loud !! tyre sound also loud !! 
the only thing i can do so far is turn on my audio sound louder 

front mirror gg

Can show pix?

didn't plan to install it so far...
some say it allow too much air flow and suffer the engine, not good for long term use...
btw, the k&n filter is oil type? original is paper type?

ya me too...I heard it since the day I fall in love with cars...

I've ask some advice from my uncles (they actually car lovers)

1 of my uncle advice is go ahead with it...somehow all the dirt will become carbon around the engine..
no harm of using it...he is using on his wrx since the 1st day...he say the only problem will occur is the warning check light on mass filter sensor will light on as too many dirt around it and it detected low air flow...he normally clean himself using contact cleaner spray..

my another uncle...not advice due to the reason I stated earlier...large air flow...more dirty flow into engine...

so conclusion...I'll wait and see..

Alamak my infortaiment couldnt detect my SD card again , Invalid SD card msg shown, I foresee it dead again soon :'( right now only glenmarie have to latest software update sigh. Love n hate for this car

Hey bro, where u update? PJ? I knew glenmarie have that. Mazda sg besi don't have the solution Sigh

Ok bro , did you service along with the software update or just went for the update? Need appointment?

Lol I saw it , ours new m3 standard is much more cooler   

my 1k service in PJ, Jalan 219 Federal Hwy, they straight away helped me update the memory card with latest software version.....didn't notice any different...   

or they installed China version.....need to pronounce as 'Jia' ??   

can just call up SC la and ask lor, they will help you I guess.