Nope...it's not a great o/c mobo...at least not as good as M2N-E.
I dont think SLI is a wise choice either, it wont give twice the performance even though u paying twice the price....unless u really got extra $.

that doesn't look like a stepping, more like a serial number...lolz

In Prime95,
FATAL ERROR: Rounding was 0.5, expected less than 0.4.

What does the message above means?

why not OC from bios...it is better....

your cold boot happen when ur OC also?

1 & 2 is obviously better than 3

between 1 & 2 ..., 2 has 'newer technology' or should i say newer chipset. 1 has very hot chipset due to sucky cooler. however personally, as a dfi fanboy i recommend dfi over abit because abit had an ugly brown pcb and there's only 2 PCI slot for those PCI add-on whores.

if you need two IDE channels, obviously you would want the DFI

try 1.4v then.. or even 1.45v.. on ur own risk ya..
i've tried mine till 1.5v still ok.. make sure ur temp not exceed 70C at load..

now i set mine 2500Mhz with 1.45v... coz 1.4v not very stable for me..

8tvt..ur still using M2N-E right??
don't think to change that mobo..??
poor 1.95vdimm really holding my ddr2 800..
coz 800 using minimum vdimm 1.95..

been thinking to change to 570infinty..
coz nF ultra II-m2 don't support 800..isit right??

ok2.. so this new screenies for that.. wahh so long to run for 32M..

finally finish it..