QUOTE(K3nnYkl82 @ Feb 27 2014, 12:16 AM)
The Resistance value of the LED rear lights are different from the Normal bulb rear lights..
The Check Engine light came on because the Etacs think there is something wrong with ur brakes .. because the resistance value different and whenever u press the brake it sense something wrong.. so it put on the Check engine light.. if u use the OBD2 reader u will get the error code something like brake switch error .
your car will just run in Limp mode if u leave it like that.
It might be very complicated .. but u just need to add a resistance to be almost identical to bulb resistance..
Wah... ETACS also control this The Check Engine light came on because the Etacs think there is something wrong with ur brakes .. because the resistance value different and whenever u press the brake it sense something wrong.. so it put on the Check engine light.. if u use the OBD2 reader u will get the error code something like brake switch error .
your car will just run in Limp mode if u leave it like that.
It might be very complicated .. but u just need to add a resistance to be almost identical to bulb resistance..
Don't know is good news or bad news...
QUOTE(nzxkore @ Feb 26 2014, 10:04 PM)
sorry if asked before.. did you tune the ECU for better fuel consumption or better performance?
done my 1st service today.. 4L + 1L EO?
Feb 27 2014, 08:35 AM

Quote
0.0211sec
0.62
6 queries
GZIP Disabled