QUOTE(joker98 @ Jan 25 2014, 02:04 PM)
I always have an OBD port scan tool, which is not too expensive nowadays with me in the car. One of the main reasons is because for my turbo Forester and since I mess around with the air intake and turbo boost sensor, there is a chance that some error crops up and my car will go into limp mode. Basically cannot drive above a certain speed and will be like a snail. The tool can erase the fault codes and let me car return to normal. But more importantly, it lets me know where the main problem is, as it reads the fault code and indicates the fault for most of the generic codes.
Also I have it so that the SC cannot bullshit me. The car has different combinations of lights to indicate different issues. But there are too many codes and there is not enough combination of lights to represent everything. For example when my main air flow sensor wire was loose (due to my own fault) the car display would say Hill Start Assist require checking with some engine and oil light on. But when checking the error code, it is specifically to the MAF sensor reading issue.
But really hope it is nothing major for you. But rats can be a problem. My previous Polo GTI had a rat die inside the bottom plate. That was horrible as I only notice it when it decomposed and there was smell and maggots coming out of the bottom of the car. Worst still I coul not access it properly without getting the car up. Later on, another rat started coming into the engine bay again. I even found pieces of chicken wing bones and bread inside my engine bay with all the rat poo. Really horrible experience.
obd port scan? did u buy it from ebay? saw one selling quite cheap...Also I have it so that the SC cannot bullshit me. The car has different combinations of lights to indicate different issues. But there are too many codes and there is not enough combination of lights to represent everything. For example when my main air flow sensor wire was loose (due to my own fault) the car display would say Hill Start Assist require checking with some engine and oil light on. But when checking the error code, it is specifically to the MAF sensor reading issue.
But really hope it is nothing major for you. But rats can be a problem. My previous Polo GTI had a rat die inside the bottom plate. That was horrible as I only notice it when it decomposed and there was smell and maggots coming out of the bottom of the car. Worst still I coul not access it properly without getting the car up. Later on, another rat started coming into the engine bay again. I even found pieces of chicken wing bones and bread inside my engine bay with all the rat poo. Really horrible experience.
Jan 25 2014, 04:27 PM

Quote
0.0540sec
0.35
7 queries
GZIP Disabled