this is black magic.. pls call potong i dont care..

http://www.lowyat.net/2013/08/21/11682/son...r-29-in-europe/

PS4 Kambing

yum yum kambing, duno when reach msia

take a video or it didn't happen

Well, i did not cook up a story... just puzzle why it can re-engage engine...
Single Occupant Vehicle....One hand Camera; One Hand Kunci ; Next ??
anyway it's my Wajunk...Cam x pro

My Lala todate has done only 300Km after 21 days; week-end car like Singapore for now...
(Running-in period; Dare not run out !! Kekeke)

This post has been edited by MEXTEMAN: Aug 21 2013, 04:53 PM

so you're saying that it's a one time affair? not replicable?

Ikut suka dia !! It comes.... intermittent !!
Resolved by replacing accelerator unit....not ECU...but b4 change , have to reset ECU on the run

why did you have to repair it? isn't it good if the engine starts immediately w/o needing to be cranked? you found a new tech, car makers would want to hear from you

Guys

To change the bulb i have to take out the whole bumper a? I see online and no instruction given, Check out some lancer thread and they say take off the whole assembly?

the bulbs here already?

ya bro. Trying to figure out how to put it

paging the DIY kings, kenny, nzh etc etc..

I just got back my lala from Juru Proton edar SC and I want to share my experience

Made appointment last week for today .... so I went there 1/2 awake at 8am in the morning to check-in my car

Service advisor was very helpful . Explained all the changes . Then she asked me whether I want to add "compressor oil" into the air-cond compressor ....

So I asked her why ? She said that the oil level in the air cond compressor will drop since the car is new. By adding a little bit of "compressor oil" , it will top up the level by a little bit. Then, this will also extend the working life of the air-cond as well

since i was 1/2 awake ... i said OK

In the quotation that she showed me , I saw Syntium 800 10W-40 (4L) and syntium 800 15W-50(1L) . So I asked her why .... she said that 1L 10W-40 no more stock ... so replace with 1L 15W-50 .... she says that it can be used ... as long as it belongs to the same Syntium 800 family

Later , I went to collect the car and pay the bill.

I asked her about the "compressor oil" ... she said "add a bit ... around 1 inch of a tube only " ... but bill was RM48 !

What !!! Rm48 for one inch of oil ?????????????????????????

So I asked more technical questions .... she said that Juru center has an air-cond specialist who recommend this product. Other places don't have this service

So I asked her for the bottle/packaging/datasheet etc ... she told me to go behind and ask the specialist ... Then the specialist showed me a tube which says E-Boost DYE for air-cond ==> Makes leaks easy to detect !

in other words , i paid rm 48 for one inch of DYE !!!!!!!!!!!!

I went to complaint that a dye does not improve the performance of the compressor and does not extend its lifespan as well . I made alot of noise as I did not agree in paying such amount of a colored dye

Finally after 15min of checking , calling ppl up , emails etc , I had the marketing brochure

http://www.uview.com/index.cfm?PAGEPATH=Pr...&PRODUCTID=5080

http://www.amazon.com/Uview-499109-eBoost-...e/dp/B003B5HVIK

It was this product .......

So I would like to ask all the sifus here whether they have ever heard of this product before ??????

Anyway once i saw the marketing brochure , I paid the total bill
Then I noticed that they put 10W-40 (1 L) in the bill instead of 15W-50 which she told me in the morning.
Apparently there was new stock

In between , I checked online and they say that if we mix Engine oils of different viscosity , we will get something in between the two different viscosity. Not sure if it was good or bad


Anyway I must puji Proton a bit after all the hentam above

1) I saw them cover the driver seat and steering wheel during the servicing with a kind of plastic cover . Good initiative as to avoid the technicians in coveralls accidently putting some grease on the car seats
2) The service advisor called me up 1 hour later to tell me that she has an expert engineer in aircond/E-Boost usage. So I told her to send me the datasheets or technical files to me email address for me to go through them


ahahah

This post has been edited by howler: Aug 21 2013, 08:01 PM

Thanks for sharing. I'm going to have my service a week after the next week. So what's your total bill?

Why repair ? If it fail during crossing road junction with trailer kambing ! u 1 repair or not !!
No car manufacturer want to listen to me coz I am just telling that from 0 km/h to push start for Auto will not work !!
But if you are already driving ; turn the key off then 'AcC' w/o cranking it will start; that's all !!


That's no fun with it as even PDT 2000 failed to pick up the problem !!

Hope it clear your doubt if any...

also the reason for buying lala

btw, one can also change gear in manual w/o engaging clutch

This post has been edited by MEXTEMAN: Aug 21 2013, 10:30 PM

mine also???
or u lupa saya ad?

Bro bulb install is from behind the lamp.
Not install from front. Unless u wanna remove whole lamp out to install bulb, then u need remove bumper.

Look from engine bay
Pop the hood.

Thanks for the heads up on this possible issue. So its the accelerator unit? Pedal unit or something else?

Well its possible for auto to engine to come alive again as long as the auto gb gears are still rolling and engaged, so you just turn the key to Acc then On again (just don't turn it to Start position where starter motor will crank). In cvt case, the chain pulleys are still engaged at that certain speed position and still rolling the wheels and the crankshaft. Turning to On just restarts the electrical, fuel injectors and spark plugs to continue combustiion process aka engine ON (hybrid does this all the time but they have different gearing to make the 2 "engines" work seamlessly).

However if you leave it rolling for a longer time w/o 'restarting', you may need to roll the car to a stop before attempting to restart to avoid damaging anything.

This reminds me of the joke... How many engineers does it take to change a light bulb...

The bulb holder is behind the lamp, accessible via bonnet area. However its a little tricky turning the mounting socket legs back once you have removed them (so please remember the socket position and which way you turn when you remove them). Also please do not touch the glass part with your bare hands. Oil from your hands will shorten the bulb life.

Torque is used for rotation, like wheel or tayar.
For straight line movement (work) is Joule.

Standard unit should Nm.
Kg-m (kg x m) is common unit, just divide the Nm by 9.8 (earth gravity force).