Greeting to all,
I have a HO Bachmann SD40-2 analog locomotive and installed with a MRC 1611 sound decoder. And I received my NCE powercab yesterday. With full excitement, finally the locomotive cranking up and all others sound functions work nicely.
When I pushed the throttle, the diesel engine sound rpm increasing BUT the locomotive no move.... I keep on pushing I think more than 50% then only can see the locomotive move a little and then all shut down.... I have been tried for few times and the result still same.
Anyone who have the idea what actually was gone wrong?

Thanks in advance.

u can try to post here

https://forum.lowyat.net/topic/242402

is that mrc1611 digital decoder with sound or just sound only?
from my previous experiences with bachmann+mrc decoders, sometimes when programming to a new address, need to do programming twice. also, bachman locos tend to pickup very slow so need to up the acceleration more compared to higher end locos

if you are in seremban you are most welcome to drop by my place and test it using my mrc or bachmann digital controllers

Hi limfreelance, Thanks. I noticed I posted in the wrong forum.

Hi Judge, nice to meet u. MRC 1611 is a propulsion sound decoder. I stayed in Melaka and not far to Seremban. Where do u stay in Seremban? Actually my kampung is near to Tampin. This is my contact 012-3169346

i'm at tmn tuanku jaafar, senawang.
just pm me boss and i think you better close this topic and continue posting in the actual thread