Jul 3 2013, 09:21 AM
QUOTE(wckan @ Jul 3 2013, 09:00 AM)
Greeting to all,
I have a HO Bachmann SD40-2 analog locomotive and installed with a MRC 1611 sound decoder. And I received my NCE powercab yesterday. With full excitement, finally the locomotive cranking up and all others sound functions work nicely.
When I pushed the throttle, the diesel engine sound rpm increasing BUT the locomotive no move.... I keep on pushing I think more than 50% then only can see the locomotive move a little and then all shut down....
I have been tried for few times and the result still same.
Anyone who have the idea what actually was gone wrong?
Thanks in advance.
is that mrc1611 digital decoder with sound or just sound only?I have a HO Bachmann SD40-2 analog locomotive and installed with a MRC 1611 sound decoder. And I received my NCE powercab yesterday. With full excitement, finally the locomotive cranking up and all others sound functions work nicely.
When I pushed the throttle, the diesel engine sound rpm increasing BUT the locomotive no move.... I keep on pushing I think more than 50% then only can see the locomotive move a little and then all shut down....
I have been tried for few times and the result still same. Anyone who have the idea what actually was gone wrong?
Thanks in advance.
from my previous experiences with bachmann+mrc decoders, sometimes when programming to a new address, need to do programming twice. also, bachman locos tend to pickup very slow so need to up the acceleration more compared to higher end locos
if you are in seremban you are most welcome to drop by my place and test it using my mrc or bachmann digital controllers
Quote
0.0743sec
0.98
6 queries
GZIP Disabled