annot access configuration


If you are unable to connect to the web-based configuration, follow the steps below:

• Verify physical connectivity by checking for solid link lights on the Ethernet ports of the device. If you do not get a solid link light, try using a different cable or connect to a different port on the device if possible. If the computer is turned off, the link light may not be on. Status light should be flashing.

• Disable any Internet security software running on the computer. Software firewalls like Zone Alarm, Black Ice, Sygate, Norton Personal Firewall, etc. might block access to the configuration pages. Check the help files included with your firewall software for more information on disabling or configuring it.

• Configure your Internet settings:

Step 1 Go to Start > Settings > Control Panel.

Step 2 Double-click the Internet Options Icon.

Step 3 On the Security tab, click to the button to restore the settings to their defaults.

Step 4 Click to the Connection tab and set the dial-up option to Never Dial a Connection.

Step 5 Click the LAN Settings button. Nothing should be checked. Click OK.

Step 6 Click the Advanced tab and then click the button to restore the settings to their defaults. Click OK.

• Check your IP address. Your computer must have an IP address in the same range of the device you are attempting to configure.

If you are still unable to access the web-based configuration you may need to reset it to defaults or reload firmware.